20
The Bloody Micks MC-172 Trainer Basic Template (Design by Jon McCarty - Jan 2011 - Rev 1.2) (CAD Drawing by Jon McCarty - Jan 2011) (Basic Template Release 1.0 - Copyright The Bloody Micks) (Contact The Bloody Micks at: [email protected]) (Please Visit Our Site at: http://bloobymicks.com) (Copyright, The Bloody Micks Jan 2011)

planta de aeromodelo

Embed Size (px)

DESCRIPTION

planta para montar aeromodelo

Citation preview

Page 1: planta de aeromodelo

The Bloody Micks MC-172 Trainer Basic Template

(Design by Jon McCarty - Jan 2011 - Rev 1.2) (CAD Drawing by Jon McCarty - Jan 2011)

(Basic Template Release 1.0 - Copyright The Bloody Micks) (Contact The Bloody Micks at: [email protected])

(Please Visit Our Site at: http://bloobymicks.com) (Copyright, The Bloody Micks Jan 2011)

Page 2: planta de aeromodelo

RECOMMENDED PARTS:

Motor: Turnigy C2830-1050 ESC: 30A ESC Battery: 1500mAh 3s Prop: APC 10x4.7 Servos: 4 Each Micro Radio & Receiver: Minimum 4-ch

Disclaimer (Please Read): • This is a design template for a high performance, high speed RC aircraft. This plane should only

be built and flown by experienced pilots with adequate skill to fly fast, maneuverable planes. • DO NOT fly this plane where it can endanger people, livestock or property. • ANY PERSONS DECIDING TO BUILD AND FLY THIS PLANE DOES SO AT HIS/HER OWN

RISK AND LIABILITY. RCFOAMFIGHTERS ASSUMES NO RESPONSIBILITY FOR THE PERFORMANCE OF THIS PLANE.

• This plane should only be launched via the side launch method. Do not attempt to launch from the top or bottom of the fuselage. Doing so can cause EXTREME BODILY HARM if any hand or body part comes into contact with the fast spinning propeller.

• All minors should fly under the supervision of an adult or guardian.

Page 3: planta de aeromodelo

The Bloody Micks FF-18 Basic Template (Design by Jon McCarty - July 2010 - Rev 1.4) (CAD Drawing by Jon McCarty - July 2010) (Basic Template Release 2.0 - Copyright The Bloody Micks) (Contact The Bloody Micks at: [email protected]) (Please Visit Our Site at: http://bloobymicks.com) (Copyright, The Bloody Micks January 2011)

Note, weight and top speed may vary depending on materials, motor, battery and electronics used. The weight given here is based on the model Jon of The Bloody Micks made using Foam Board Covered in colored sealing tape.

Basic Specs as built by The Bloody Micks: Wingspan: 25.88 Inches (65.74cm)

Length: 36.7 Inches (93.22cm)

All Up Weight (AUW): (AUW): 25oz. (708.75g) with Basic Setup

Copy Disclaimer The Bloody Micks grants permission for this plan to be copied at local copy houses for personal use only. This plan may not be Sold, or Altered to remove The Bloody Micks contact information or instructions. (Contact The Bloody Micks at: [email protected])

Page 4: planta de aeromodelo
Page 5: planta de aeromodelo

p1, row1, col1

Page 6: planta de aeromodelo

p1, row1, col2

Page 7: planta de aeromodelo

p1, row1, col3

Page 8: planta de aeromodelo

p1, row1, col4

Page 9: planta de aeromodelo

p1, row2, col1

Page 10: planta de aeromodelo

p1, row2, col2

Page 11: planta de aeromodelo

p1, row2, col3

Page 12: planta de aeromodelo

p1, row2, col4

Page 13: planta de aeromodelo

p1, row3, col1

Page 14: planta de aeromodelo

p1, row3, col2

Page 15: planta de aeromodelo

p1, row3, col3

Page 16: planta de aeromodelo

p1, row3, col4

Page 17: planta de aeromodelo

p1, row4, col1

Page 18: planta de aeromodelo

p1, row4, col2

Page 19: planta de aeromodelo

p1, row4, col3

Page 20: planta de aeromodelo

p1, row4, col4