Upload
others
View
4
Download
0
Embed Size (px)
Citation preview
1 - Remove old mattress, clear offplatform. Roll out paper across the
Headboard or Bulkhead.
2 - Cut small V-Slits on each side. 3 - Tape paper down. Be sure to keep edge of paper even
with Headboard or Bulkhead.
4 - Crease paper with finger.
5 -Follow with pencil. 6 - Look closely to see if nightstandhas molding that extends out over
the base of the nightstand.
7 - If so, a notch or additional fingerspace can be added.
8 - To measure, place a squareagainst the over hang.
9 - Draw a small line at base of squareevery few inches around the
perimeter of nightstand.
10 - Crease paper in remaining areaand follow with a pencil.
11 - Roll out 2rd layer of paper, tapedown to 1st layer.
12 - Crease edges with finger and follow with a pencil.
13 - Roll out 3rd layer of paper, tape down to 2nd layer.
14 - Crease the edges into the cornerand finish with a pencil.
15 - Be sure to mark hinge fold if youwant a hinge. Also mark the head
location & any other notes needed. If you have a difficult area to explain,
attach photos.
16 - Once pattern is complete, be sure to put your name and
phone number on it and send it to your nearest location.
WALK-AROUND HANDCRAFT MATTRESS COMPANY
STEP-BY-STEP GUIDE ON CREATING YOUR OWN CUSTOM PATTERN WWW.BOATBEDS.COM
ONCE WE RECEIVE IT, WE WILL CONTACT YOU WITH ANY QUESTIONS & CONFIRM PRICING. YOU CAN USE A CREDIT CARD OR PAY BY CHECK.
QUESTIONS? CONTACT US AT: 1.800.241.7751