Click here to load reader
Upload
vunguyet
View
213
Download
1
Embed Size (px)
Citation preview
Co
ncr
ete
Rep
airs
Product Data Sheet
Grandfix Skim Coat 111 Ultra paste skim Smoothing to be mixed with cement
Product Description Is a skim smoothing ultra paste compound specially formulated
to be mixed with cement for rendering and finishing uneven concrete surface and pre-casts concrete panels. When mixed with cement, the products exhibit very good trowel ability application and excellent bond to the concrete surface. It is designed for indoor and outdoor use as a skim smoothing up to
3 mm for walls and ceilings.
Customer Benefits
Recommended for
Excellent bond to the concrete substrate
Application thickness up to 3mm
Good trowel ability
Smooth finish – important for the application of decorative finish
Serves as initial coat for painting purposes
Yields homogeneous paste that eliminates surface crack lines
Thin plastering of interior and exterior walls and ceilings.
Filling pinholes prior to over coating
General repro filling over large areas of concrete up to
3mm
Instruction for Use 1. Substrate preparation
Clean the surface and remove any dust, unsound material, plaster, oil, paint, grease, algae, curing compound and traces of foreign materials.
2. Mixing
Stir GRANDFIX SKIM COAT 111 before mixing with cement. Mix 1 (one) part of GRANDFIX SKIM COAT 111 with 0.5 to 1 part of cement until a homogenous paste is achieved. NO water must be added.
3. Application
Apply the mixed GRANDFIX SKIM COAT 111 to the prepared surface using steel trowel up to 3mm thickness. Allow 2 – 3 hours depending on the temperature between coats. Do not proceed with the application when rainfall is imminent unless in a sheltered or protected situation
4. Finishing
Plastic floats maybe used to achieve desired surface texture, but care should be taken not to overworked the surface.
Physical Properties Appearance : off-white to light grey paste
Paste Density : 1.42 ± 0.10 kg/liter Mixed Density (1 part paste : 1 part of cement)
: 1.82 ± 0.10 kg/liter pH (paste) : 7 – 8 Pot Life : approx 1 – 2 hours depending on the
temperature Compressive strength : ASTM C109 7 days : 2,500 psi 28 days : 3,200 psi
Co
ncr
ete
Rep
airs
Estimating Data Approximately 0.65 – 0.85 kg/m
2 at 1mm thickness.
Packaging GRANDFIX SKIM COAT 111 is supplied in 25 kg PE pail.
Storage Store in dry conditions in the original, unopened container.
Shelf Life GRANDFIX SKIM COAT 111 has a shelf life of 12 months if
maintained in dry storage conditions in unopened original container.
Health and Safety GRANDFIX SKIM COAT 111 is non-toxic. Wear suitable
protective clothing, gloves and eye protection. In case in contact with eyes, rinse immediately with plenty of water and seek medical advice. If swallowed, seek medical attention immediately – do not induce vomiting.
Fire GRANDFIX SKIM COAT 111 in non – flammable.
Important Note The information contained in this leaflet is published to the best of our knowledge and is supported by current available data. Hence, subject to the care and method of application, deviations (from published values) in performance may occur. Our guarantee is therefore limited to the quantity of the supplies material.
Grand Aces Ventures Inc Unit 3 & 4, 138-142 M.L Quezon Avenue, Brgy. San Isidro, Angono, Rizal, Philippines Tel. Nos. +63 (2) 451-0160, 571-6021, 451-0927, 451-0915 Fax No. +63 (2) 571-6023 Email: [email protected] Website: www.grandacesventures.com