Upload
anturi-technology
View
229
Download
3
Embed Size (px)
Citation preview
Tag4M Datasheet
Tag4M Datasheet v0.1
2
Copyright © 2010 Anturi Technology, SL www.anturitech.com
Key features
Dimensions: 65 mm x 48 mm (2.55" x 1.88")
32-bit RISC processor
2.4 GHz IEEE-802.11b/g WiFi transceiver
4-channel 14-bit A/D converter
Onboard ceramic chip antenna and U.FL connector for external antenna
Onboard temperature sensor: thermistor (Murata NCP18XH103F03RB) 10K +/-1 ºC
32 KHz real-time clock (for wakeup and timestamping)
Data buffer for up to 10,000 readings in RAM and 30 readings in non-volatile
memory
Maximum sampling rate: 3.3 Hz
Radio characteristics
Device: G2M5477 (G2 Microsystems)
Frequency 2402 ~ 2480 MHz
802.11b compatibility: DSSS (CCK-11, CCK-5.5, DQPSK-2, DBPSK-1)
802.11g: OFDM (default)
Channels interval: 5 MHz
Channels 1 – 14, configured for Ch 6
Transmission rate: 1 – 11 Mbps for 802.11b / 6 – 54 Mbps for 802.11g
Receive sensitivity: -85 dBm typ
Output level(Class 1): +18 dBm
Maximum RF input to U.FL connector: 10 dBm
Memory
ROM 512 Kbytes (for the eCos operative system, TCP/IP, LWIP and security
firmware)
RAM 128 Kbytes (64 Kbytes available for user application)
Non-volatile memory (NVM) 1536 bytes (1024 bytes available for user application)
(SPI) EEPROM 125Kbytes (tag firmware, Save to Flash data)
Tag4M Datasheet v0.1
3
Copyright © 2010 Anturi Technology, SL www.anturitech.com
Operating modes
Web mode: Remote data access through Tag4M Web Page Instrument
Local mode: Data access through a PC in the same LAN with the access point
Measurement capabilities
1 analog-input channel (0 - 10 V)
3 analog-inputs channels (-200 mV; +500 mV)*
1 analog-input channel (4 – 20 mA)
4 digital I/O lines
*two analog channels can also provide excitation current between 0.2 and 200 µA
Power consumption
Boot-up period:: (5 - 52 ms) 25 mA
sleep mode: 4 - 10 µA
standby (doze) mode: 15 mA
Connected (idle, RX): 40 mA
Receiving data (Rx): 50 mA
Receiving data + measurement period: (50 - 90 ms) 60 mA
Transmitting data (Tx) period (1 - 5 ms): 140 - 212 mA
Power
Onboard battery: CR-123A 3 V, lithium, 1550 mAh
3.3 V external power source
Tag4M Datasheet v0.1
4
Copyright © 2010 Anturi Technology, SL www.anturitech.com
Environmental conditions
Operating/storage range: 0 a 70 ºC*
Relative humidity, operating/storage: 90%
*extended version allows an operating/storage range from -40 to 85ºC
Compliance information
FCC: ID U3O-G2M5477 15.247
IC (Canada): RSS-210
CE: EU ID # 0681
REG: U9M20901-1000-C
Radio: EN 300328 V1.7.1 (10/2006)
EMC: EN 301489-1 V1.8.1 (04/2008), EN 301489-17 V1.3.2 (04/2008)
Safety: EN 60950-1:2001+A11:2004
RoHs compliant
Tag4M Datasheet v0.1
5
Copyright © 2010 Anturi Technology, SL www.anturitech.com
Connectors
PIN Analog connector J2 Digital connector J3
1 0 - 10V (V+ signal line) VEXT (3.3V V+ signal wire from external
power supply)
2 AGND (analog ground) DGND (digital ground)
3 4 - 20mA (I+ signal line) 3.3V OUT
4 4 - 20mA (I- signal line) DGND (digital ground)
5 Is (analog ground for current
measurement)
DIO3 (digital line channel 3 or Rx in
RS232 communication mode)
6 AI0 (V+ signal wire for low-voltage
measurement channel AI0)
DIO2 (digital line channel 2 or Tx in
RS232 communication mode)
7 AI1 (V+ signal wire for low-voltage
measurement channel AI1) DIO1 (digital line channel 1)
8 AI2 (V+ signal wire for low-voltage
measurement channel AI2) DIO0 (digital line channel 0)
9 AGND (analog ground) DGND (digital ground)
Tag4M Datasheet v0.1
6
Copyright © 2010 Anturi Technology, SL www.anturitech.com
Disclaimer:
This document contains information provided by the manufacturer (Core Electronics LLC), so
Anturi Technology SL is not responsible if the information contained is not accurate.
Cores Electronic LLC reserves the right to make corrections, modifications and other changes
to its products, documentation and services at any time. Customers should obtain the latest
relevant information before placing orders and should verify that such information is current
and complete. Cores Electronic LLC assumes no liability for applications assistance or
customer product design. Customers are responsible for their products and applications
using Cores Electronic LLC components. To minimize the risks associated with customer
products and applications, customers should provide adequate design and operating
safeguards. Cores Electronic LLC products are not authorized for use in safety-critical
applications (such as life support) where a failure of the Cores Electronic LLC product would
reasonably be expected to cause severe personal injury or death, unless officers of the
parties have executed an agreement specifically governing such use. All other trademarks
are property of their respective owners.
Tag4M image and Tag4M name are trademark of Cores Electronic LLC.