Embed Size (px)
DESCRIPTION
3D-modelling for hydraulic assembly Preliminary design of the TS “Balcony unit” in USA15. Kirill Egorov Indiana University. TS “Balcony unit”… Where is the balcony?. It’s here! USA15 level 3. Where is the compressor room to connect the “balcony unit”?. Keep in mind this white column!!!. - PowerPoint PPT Presentation
Citation preview
5th Thermosyphon Workshop 1
Kirill EgorovIndiana University
20 October, 2011
3D-modelling for hydraulic assembly
Preliminary design of the TS “Balcony unit” in USA15.
5th Thermosyphon Workshop 220 October, 2011
TS “Balcony unit”… Where is the balcony?
It’s here! USA15 level 3
5th Thermosyphon Workshop 320 October, 2011
Where is the compressor room to connect the “balcony unit”?
Keep in mind this white column!!!
…and this cable tray
5th Thermosyphon Workshop 420 October, 2011
The white column is a part of the
USA15 ventilation
system.
Where is the bottom part?
5th Thermosyphon Workshop 520 October, 2011
This is the bottom
part of the white
columnThis is
the botto
m part
of the cable tray
Compressor room
door
Keep in mind these two red
areas in front of and behind the
tank
12
5th Thermosyphon Workshop 620 October, 2011
The compressor room is found!
The compressor room entrance is under this
line
The tank is under this white area
1
23
5th Thermosyphon Workshop 720 October, 2011
…and without drilling of ceiling
3
3
30 cm
5th Thermosyphon Workshop 820 October, 2011
“Balcony unit” – 3D modelling of components31kW electric
heater
Filters
56kW heater
Dummy-load
Heat-exchanger for sub-cooling
Flowmeter
5th Thermosyphon Workshop 920 October, 2011
“Balcony unit” – 3D assembling
This assembling
doesn’t include a
support frame
There are ~760 3D-solids
here
5th Thermosyphon Workshop 1020 October, 2011
“Balcony unit” – 3D assembling
Blue pipes need thermal
insulation
5th Thermosyphon Workshop 1120 October, 2011
“Balcony unit” – 3D integration
1
2
3
4
There are four fixing point for
the balcony
The support #4 is standing on the roof of the
compressor room
~2450 kg without support frame
5th Thermosyphon Workshop 1220 October, 2011
“Balcony unit” – 3D integration
warm liquid to detecto
r
cold vapor to
condenser
warm vapor from
detector
cold liquid from
condenser
5th Thermosyphon Workshop 1320 October, 2011
“Balcony unit” – 3D integration
1,4 m
<1,2 m
>3 m
5th Thermosyphon Workshop 1420 October, 2011
Conclusion
• There are 3D models for all “Balcony unit” components.• The preliminary design is ready.• The design of the supporting frame will be ready soon after approval of all the components.• The strength of the balcony needs a confirmation from the CERN civil engineering.
