Embed Size (px)
Citation preview
Issued January, 2010
Horiba Legacy
Dynamometers
Series DD, DV, and Twin Roll
Continuation of Product Life
Electrical Upgrades
Index
Horiba Legacy Dynamometers
Electrical Upgrades for Continuation of Product Life
Prime ONE is committed to continuing support for Horiba legacy dynamometers. As a result, we offer several solutions to replace or rebuild existing equipment. We can also integrate our controls and hardware retrofits to work on other manufacturers’ equipment. Our product line that supports legacy equipment is as follows:
1) CDC-1000 Control Upgrade .......................................... DV & Twin Roll Machines
This upgrade is intended to replace the DOS based control system used on older Horiba dynamometers. It includes replacement of the CDC-900 backplane and RTM computer with a Windows based control system.
2) CDC-1000 Control Upgrade—Standalone ........................... DV & Twin Roll Machines
This is the CDC-1000 upgrade built as a standalone cabinet for situations where a standard CDC-900 cabinet is not present. This option can be integrated to work on other manufacturers’ equipment.
3) Power Converter Upgrade ............................................ DV & Twin Roll Machines
This upgrade replaces the discontinued Baldor/SWEO drives found in older series Power Converters. It involves a complete replacement of the Power Converter backplane. The ratings of the system can also be increased at the customer’s request. This upgrade can also be implemented with the DD series dynamometers to achieve higher capacities.
4) RTM Computer Upgrade ............................................................... All Machines
This upgrade replaces the user interface RTM computer. It uses a small form factor Mini-ITX motherboard which greatly reduces the chassis size. This computer can be installed with Windows, DOS, or both and additional hardware can be added at the customer’s request.
5) CDC-900 Processor Upgrade ......................................................... All Machines
This upgrade replaces the Black Box CPU in any Horiba dynamometer controller. It includes a new half-size single board computer, Disk-On Module hard drive, and new serial port cards.
Replaces Horiba DOS
Control Systems For
Twin Roll & DV Dynos
Fits Into Your Existing
CDC-900 Cabinet!
Includes:
▫ New User Interface Computer
▫ New CDC-1000 Control Panel
▫ Windyno Control Software
CDC-1000 Upgrade
Replaces Outdated Horiba DOS-Based
LDV & Twin Roll Dyno Control Systems
Can Be Integrated to Work on Other Systems
Includes:
▫ New User Interface Computer
▫ Standalone CDC-1000 Controller
▫ Windyno Control Software
CDC-1000 Upgrade—Standalone
Replaces Horiba
Twin Roll & LDV Dyno
SWEO Drive Equipped
Power Converters
(As shown for LDV Power Converter)
Includes:
▫ New Back Panel
▫ New Baldor 22H Main Drive
▫ New Baldor 18H Bearing Drives
▫ New Breaker, Contactors & Relays
Features:
▫ Capacity Increase up to 300HP
▫ Fits into Existing Power Converter
Power Converter Upgrade
Replaces RTM
User Interface Computer
For any Horiba Dyno
Features:
▫ Compact Mini-ITX Tower
▫ Windows XP & DOS
▫ 17” LCD Monitor
RTM Computer Upgrade
Replaces Old CPUs and Memory Modules for
DV, DD & Twin Roll Black Box Control Units
As Shown with New Serial Cards for DV and Twin Roll Systems
Requires Only Processor and DOM Assembly for DD System
CDC-900 CPU Upgrade
Our new facility is located only minutes down the
road from Gerald R. Ford International Airport
Contact Information
Prime ONE Contracting
4600 Danvers Drive SE
Grand Rapids, MI 49512
Phone 616.949.3333
Fax 616.949.7599
While in the area enjoy beautiful
downtown Grand Rapids!
