International Conference on Electrical Engineering and Informatics 2013 (ICEEI 2013)

Title of Paper

First Authora, Second Authorb, Third Authora,b,*

aFirst affiliation, Address, City and Postcode, CountrybSecond affiliation, Address, City and Postcode, Country

Abstract

Insert abstract of paper.

© 2012 The Authors. Published by xxx. Selection and/or peer-review under responsibility of Faculty of Information Science and Technology.

Keywords: Type your keywords here, separated by semicolons ;

1. Title of section 1

Insert contents of section 1. Please save your file as iceei2013_authorlastname.docx. File must be in MS word and PDF format only.

Bulleted lists should look like the following example:

Point 1 Point 2 Point n

Figures and tables should be embedded and not supplied in separate files.All photographs, schemas, graphs, diagrams and program code are to be referred to as figures. Figures should look

like the following example, see Fig 1:

(a) (b)

Fig. 1. Illustration of subject X in (a) condition A and (b) condition B.

Headings of tables should be placed above tables, center justified. Leave one line space between the heading of the table and the table. Only horizontal lines should be used within a table, and tables should look like the following example:

* * Corresponding author. Tel.: +0-000-000-0000 ; fax: +0-000-000-0000 .E-mail address: author@institute.xxx

Author name

Table 1. Caption for table

Column 1 Column 2 Column 2

Entry 1 1 2

Entry 2 3 4

Entry n 5 6

Equations and formulae should look like the following example, and they should be separated from the before and after texts by one line space. Refer to equations in the text as "Eq. (1)"

(1)

ρ= E⃗

JC (T=const . )⋅( P⋅( E⃗EC )

m+(1−P ))

(2)

Footnotes should be avoided. If necessary, footnotes should be typed single spaced using font size 8 pt, at the foot of the page in which they are mentioned.

References should be listed at the end of the paper, and numbered in the order of their appearance in the text. References should be indicated in the text by full-size numbers in brackets, e.g., [1], [2-3].

1.1. Title of sub-section 1.1

Insert contents of sub-section 1.1.

1.2. Title of sub-section 1.2

Insert contents of sub-section 1.2.

2. Title of section 2

2.1. Title of sub-section 2.1

Insert contents of sub-section 2.1.

2.2. Title of sub-section 2.2

Insert contents of sub-section 2.2.

Acknowledgements

Insert list of those who helped in the research or in the preparation of the paper.

References

[1] Lastname, A., 2013. Title of Article, Name of Journal 12, p. 123.[2] Lastname1, A., Lastname2, B., 2013. Title of Article, Name of Journal 12, p. 123.[3] Lastname, Middlename A., 2013. Title of Book, Name of Publisher, Publishing Place.

Author name

[4] Lastname1, A., Lastname2, B., De Lastname3, C., 2013. Title of Article, in “Title of Edited Book” D. Lastname, Editor. Name of Publisher, Publishing Place, p. 123.

[5] Lastname1, A., Lastname2, B., Lastname3, C., 2013. “Title of proceeding article,” Title of Proceeding - Proceedings of the 4th International Conference on Electrical Engineering and Informatics, pp. 123-129.

[6] Lastname1, A., den Lastname2, B., Lastname3, C., Lastname4, D., Lastname5, E., Lastname6, F., Lastname7, G., 2013. “Title of proceeding article,” 4th International Conference on Electrical Engineering and Informatics. Selangor, Malaysia, paper #B08.

[7] Title of Report: Annual Report for 2013, Name of Institution, June. 2013.

Appendix A. Title of appendix A

Appendices should be added after References, and should be ordered as A, B, C etc.

A.1. Title of a sub-heading within an appendix

An appendix may contain sub-headings, if necessary.