1

Click here to load reader

Diagram for the Implementation of the EN 81-1/2:1998+A3:2009 (UCM) Standards in our Products

Embed Size (px)

DESCRIPTION

In view of the numerous doubts and queries from you, concerning the compliance with Standards: EN 81-1:1998+A3:2009 and EN 81-2:1998+A3:2009, we have produced a diagram in order to explain the processes relating to our products. This is an explanatory diagram that is constantly updated. As soon as there are any modifications in it, you will be informed by this same channel. We hope this information may be of use and help to you. http://dynatech-elevation.com/pub/documentos/documentos_cuadro_UCM_v01_ingles_2abea81a.pdf

Citation preview

Page 1: Diagram for the Implementation of the EN 81-1/2:1998+A3:2009 (UCM) Standards in our Products

 

+

+

A3 Requirements: 

Item 9.11 of EN81‐1:1998+A3:2009 

‐ car stop must be caused without exceeding 1.20 m 

‐ ascending deceleration of 1 g must not be 

allowed and the values accepted for the safety gears must be allowed 

in descending deceleration  

 

Safety Elements 

 

Drive Machine 

Per Unit

The customer has a unit certified as UCM and does not need to check the requirements requested in the A3 at 

his/her installation 

Per Component

The customer makes the UCM solutions according to his/her needs; however he/she must 

be held responsible for checking that the unit meets the A3 requirements in his/her 

installation

Tornado + Dynatech control System (CDC‐060 

and BFS‐059) 

Tornado + Controller  To be certified by the operator 

Governors 

In the process to be certified 

In the process to be certified

Safety gear

Dynatech Steering Mechanisms 

Control System 

Controller  To be certified by the controller