Chapter 5Server Installation
• NT Server Requirements
• NT Server File Systems
• Installation
NT Server Requirements
• 32-bit bus computer with an 80486 25 MHz or better processor
• VGA or better solution monitor
• High density 3.5 -inch floppy disk
• CD-ROM drive
• 16 MB or more memory
• One or more hard disk with 148 MB
• Network interface card
NT Server File Systems - I
• Security: Backup, trust and privilege, etc,
• File compression
• File size: 64 GB
• File activity information: log or journal
• File recognition– NTFS– FAT
NT Server File Systems - II
• Server domain– One network with many domain– One or more server in the same domain or
different one
• Server types– Primary domain controller (with security
accounts database)– Backup domain controller (two or more
servers)– Standalone server (database)
NT Server File Systems - III
• Emergency repair disk– drivers– NTFS file system– NT server operating system
Installation Preparation Task - I
• List of hardware components
• Hardware configuration information (BIOS)
• NT server system requirement
• What partition to use (C or D)
• File system
• Name of NT directory
• Name of the server
Installation Preparation Task - II
• Password for administrator account (less 14 characters)
• Type of server
• Protocol selection - NetBEUI
• Name for the domain
• Emergency repair disk
Installation - I
• Boot computer with Setup disk 1 in drive A
• Put Setup disk 2 in drive A as requested
• enter
• Enter
• Enter
• Put Setup disk 3 in drive A as requested
• Enter
Installation - II
• Enter
• Insert Windows NT Server CD_ROM
• Enter
• F8
• No Changes: The above list matches mu computer
• Enter
Installation - III
• Enter
• Convert the partition to NTFS
• Enter
• Accept default
• Enter
• Exhaustive examination
• Enter
Installation - IV
• Remove CD_ROM and floppy disk
• Enter (computer reboot by itself)
• Load CD_ROM
• OK
• Next (Follow the Setup Wizard)
Installation - Licensing
• Name: your full name
• Organization: CSUS
• Next
• Registration
• Next
• 5 per server (Licensing Modes, leave per seat unchecked)
• Next
Installation - Server Name & Type
• Computer name: CSUSMIS
• Next
• Type: Primary Domain Controller
• Next
Installation - Administrator
• Administrator account: less than 14 characters for password
• Next
• Emergency repair disk: yes
• Next
Installation - Software
• Default
• Next
Installation - Windows NT Setup
• Next
Installation - Networking
• Wired to the network
• Next
• Do not check the option to install Microsoft’s Internet Information Server software
• Next
Installation - NIC
• Start search
• Next
• NetBEUI protocol (leave other unchecked)
• Next
Installation - Network Services
• NetBIOS interface
• Workstation
• Server
• Next
Installation - Network Components
• Next
• Continue
• Next
Installation - Network Communications
• Next
• Type CSUSMIS for computer name
• Type MIS_DATA_COM for domain name
• Next
Installation - Configuring NT Server - I
• Finish
• Data & Time tab
• Enter current date & time
• Time Zone tab
• Select proper time zone using scroll box
• Close
• OK
Installation - Configuring NT Server - I
• Insert a blank disk in drive A
• OK
• Remove the newly created Emergency Repair Disk
• Restart computer
Packbell Hardware
• IDE CD-ROM (ATAPI 1.2) IDE Controller
• Hard disk: ST3660A– No of cylinder: 1057– No of head: 16– No of sector: 63– Size: 520MB
• RAM: 640 and 16MB