Upload
others
View
0
Download
0
Embed Size (px)
Citation preview
ROCAVICTORIA WALL BASIN 520 WITH SEMI PEDESTAL
FEATURESRecommended Use Domestic, hotel or commercial
Weight Basin - 13.4kg / Semi Pedestal - 9.0kg
Fixing Wall-mounted
Pedestal Full pedestal and semi-pedestal available as options
CLEANING RECOMMENDATIONSSoapy water or approved bathroom cleaners. This bathroom product should not be cleaned with abrasive materials. Damage caused by any improper treatment is not covered by the product warranty. Refer to Warranty Page for full Terms and Conditions.
To see the complete Roca range go to www.reece.com.au/bathrooms
SPECIFICATIONFixing Requirements Wall basin fixing bolts supplied
Integral Overflow Yes
Tap Hole Availability 1 or 3 tapholes
Plug & Waste Suits 32 x 40mm overflow waste
Water Capacity 5 litres
Colour Availability White
A B C D E650 510 520 335 205560 460 450 295 205520 410 415 255 190
520280
850345
200
415295
475345
850
410255
Dimensions are nominal only
page 1 of 3
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor takes no responsibility for printing errors.
Tech Page Version 1
ROCAVICTORIA WALL BASIN 520 WITH SEMI PEDESTAL
Basin
Locknut
Bolt
Nylon
Wall
Noggin
Section throughbasin using wallfixing bolts
*Basin can be installedindependantly of pedestalif desired.
Bush / Washer(fig 1)
INSTALLATION INSTRUCTIONSNote: All measurements are taken from finished wall and floor. If basin is installed at different height to that recommended,all other measurements must be adjusted accordingly. If fixing to timber framed walls or partitioning, the wall should be reinforced with noggins to receive fixing bolts/screws for both the basin and the semi-ped.
• Drill holes into walls at recommended height and fixing centres and install fixing bolts supplied (fig 1).• Fit selected tapware to basin. Fit the supplied overflow waste to basin ensuring it is sealed with silicone on top.
• Carefully align basin complete with fittings onto protruding bolts.
• Insert nylon bushes and locking nut and partially tighten lock nuts to hold basin into position. Make minor adjustments at thisstage to ensure basin is level and then fully tighten lock nuts. Do not over tighten.
• If desired all visible external edges can be joint sealed using flexible sealant ensuring to wipe off any excess.
• For fitting of semi-ped under basin, please refer to pictorial steps 3 to 8. Make minor adjustments to basin height if requiredbefore finally tightening basin locking nuts.
VICTORIAA336312..R
1 2
850-XX
1 2
850
Ø12 17
page 2 of 3
Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference
INSTALLATION
ROCAVICTORIA WALL BASIN 520 WITH SEMI PEDESTAL
A39
2501
120a
3 4
5 6
87
Ø10
10
1
17
1
2
x2
2
Roca Sanitario, S.A.Avda. Diagonal, 51308029 Barcelona -SPAINTeléfono 93 366 1200Fax 93 419 4501www.roca.es
page 3 of 3
Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference
INSTALLATION