Soal2 AutoCAD.pdf

7/30/2019 Soal2 AutoCAD.pdf

1/19

Figure 1. To make this object, notice the absolute coordinate location of the smallercircle (4,4.5) which is where you are going to start with. And the rest of the object

follows with it.

Figure 2. This object is made with the advantage of the direct distance entrycommand to first make the perimeter (first without the curves). The curves in the

sides can be made by using the filletor circle-ttrcommand then trim.


2/19

Figure 3. Again notice the absolute coordinate location of the line in 1, 3 and thepoint in 5,7 which is where the rest of the drawing follows.

Figure 4. This object again has absolute coordinates to follow. This is made throughcircles-2P, lines, and ars (start-center-radius).

Figure 5. To make this object, start with the line, then the arcs. The center of thearc in 45 is the endpoint of the location 1.50.

Figure 6. This drawing again has absolute coordinate locations to follow. Thetriangle is made by following those commands given in numbered order. To circle

inside the triangle is made through cicle-ttrcommand.


3/19

Figure 7. Though this object can be made through lines and arcs, the objective is tomake this one using polylines wherein the lines and arcs are connected.

Figure 8. This object starts with the smaller circles with the diameter or 0.50 andthe rest follows. A circle-ttrcommand is more useful than using arc to make the

curves.


4/19

Figure 9. This object is almost similar to figure 9 which also starts with the smallercircles. Again a cicle-ttrcommand is used here than arcs to make the curves. Tocopy the arc inside or outside at a different radius, the offsetcommand could be

useful.

Figure 10. In this objects the direct distance entry could be useful to make theperimeter. For the curves on the edge, filletcommand could also be used. Relative

rectangular entry with snap-from command could locate the circles center. Tomake the dash-dot center line you need to load the line in the linetype box.


5/19

Figure 11. The objective of making this object is to learn the array(rectangular and

polar) command. There are a total of 176 smaller circles. There are 40 circlesaround each inner circles and 96 circles inside.

Figure 12. This exercise will help you use the chamfercommand which will helpyou make the cut on the edge. The mirrorcommand is also used to reflect an

object to its opposite side.


6/19


7/19

.


8/19


9/19


10/19


11/19


12/19


13/19


14/19


15/19


16/19


17/19


18/19


19/19

Documents

Soal2 AutoCAD.pdf