Digital power distribution Enables you to control your boat´s power in a tailored, efficient and virtually cable-free way.

control your power

Power the quick and easy way

With the SeaZone products, you can create a secure, effective and totally integrated system to control all the electrical functions on your boat. In addition to being quick and easy to install, it can readily be adapted to match your own specific require-ments. Powering up your boat couldn’t be simpler!

Total control and security at sea

SeaZone gives you total control over all your electri-cal equipment via an intuitive and easily-used interface. You receive continuous information on electricity consumption per unit, as well as under- and overload warnings. With SeaZone, you need never again worry about not having enough power in your battery. Since you always know how much power is left, you can prioritize and economize your consumption, so you’ll never run short for the things that are most important.

Goodbye cable jungles!

The system’s innovative construction concept has radically reduced the need for cable connections. All control functions (switches, buttons, knobs, panels etc.) are integrated and programmed to communicate digi-tally with every item of equipment. This cuts the number of cables to one thin network cable – obviously a huge advantage on boats, where space is at a premium and pulling cables can often be a nightmare. An additional bonus is that power transmission is improved by a reduc-tion in the number, thickness (cable area) and length of cables.

Personalise your power Simpler and faster installations

With SeaZone in place, it’s a simple matter to configure each item of equipment and to expand the system with new functions and components. For instance, you can programme lanterns to be switched on and off according to a pre-determined pattern, or a series of events to take place at the push of a button. A switch can be designated “harbour position”, for example: then specific electrical functions would be activated such as on-deck lighting, operation of freshwater pump, etc.

The SeaZone electrical system is simple to install. Learning how the system works is a cinch, and with our range of products it’s easy to get all the boat’s electrical devices up and running with your tailor-made functions. A major benefit is the reduction in the number, length and thickness of the electrical cables. The majority of cables disappear entirely, being replaced by one thin network cable, which makes the in-stallation process a lot faster and easier.

These products can be installed and used in a wholly integrated system or independently of one another, depending on specific needs and the existing structure of your electrical system.

powerZone is the power distribution unit and the heart of the SeaZone system. Housing safety fuses and microprocessors, it runs the programming and control functions for all the boat’s electricity-consuming devices and components. It’s possible, for instance, to configure every device for functions like interval con-trol, pulse and blink, minimum and maximum current strength, etc. This is done either directly on powerZone’s recessed screen or via a computer.

The system is operated either via SeaZone’s own switch panels (controlZone) or via existing Carling switches, buttons and instrument panels. To connect existing buttons and panels to powerZone, an intermediate connection is required via our power distribution board ioZone. It connects and receives both digital and analogue signals, packeted and communicated digitally to powerZone via an ordinary network cable (CAN Bus). Up to three powerZones can be serially connected to, and controlled by, one ioZone. There is, however, no upper limit as to how many power-Zones that can be serially connected. Each powerZone has eight output terminals that can control the corresponding eight electri-cal devices.

If one or more powerZone units are placed close to the electrical equipment being controlled, in the stern for example, and controlZone and/or ioZone units are installed in the instrument panel further down the boat, then you can avoid a jungle of cables and tangled wires. This is because only a thin network cable connects control instruments, buttons and electrical devices. If instead one or more of SeaZone’s panels – control-Zones – are used, then an intermediate connection via ioZone will not be needed since the controlZone unit is directly connected to powerZone via a network cable.

The SeaZones system consists of four products:

A comprehensive and powerful product programme

powerZone

ioZone

fuseZone

controlZone

Simple

SecureFast

Control

Effective

Individual

Practical electrical functionsThe SeaZone electrical system has many pre-programmed functions that meet most electrical needs on a boat.

Some examples:

• Windshield wiper.

• Continuously variable functions e.g. dimmer and defroster (regulates speed and enables stepless control from zero to 100 percent).

• Total control over all electrical equipment, so that you know that all components are working as they should.

• The system can warn and protect against the under- and overloading of all electrical components. This gives real security to a skipper who must defy the elements and other hazardous conditions throughout the year.

SeaZone’s Iphone app gives you the freedom to control all electrical units on the boat wire-lessly and from any-where in the world.

To make an enquiry or place an order, please contact us at:

+46 8 715 70 30

info@seazone.se

www.seazone.se

Postal address:

SeaZone AB

Svarvarvägen 1

132 38 Saltsjö-Boo

SWEDEN