Embed Size (px)
Citation preview
Quantification of strong emissions of methane in the
Arctic using spectral measurements from TANSO-FTS
and IASI
Zakia Bourakkadi, Sebastien Payan, Jerome Bureau
To cite this version:
Zakia Bourakkadi, Sebastien Payan, Jerome Bureau. Quantification of strong emissions ofmethane in the Arctic using spectral measurements from TANSO-FTS and IASI. EuropeanGeosciences Union General Assembly 2015, Apr 2015, Vienne, Austria. pp.EGU2015-3243.<hal-01142226>
HAL Id: hal-01142226
https://hal.archives-ouvertes.fr/hal-01142226
Submitted on 20 Apr 2015
HAL is a multi-disciplinary open accessarchive for the deposit and dissemination of sci-entific research documents, whether they are pub-lished or not. The documents may come fromteaching and research institutions in France orabroad, or from public or private research centers.
L’archive ouverte pluridisciplinaire HAL, estdestinee au depot et a la diffusion de documentsscientifiques de niveau recherche, publies ou non,emanant des etablissements d’enseignement et derecherche francais ou etrangers, des laboratoirespublics ou prives.
B) IASI
Quantification of strong emissions of methane in the Arctic using spectral measurements from TANSO-FTS and IASI
Z . BOURAKKADI1 , S. PAYAN1, J. BUREAU1
1- Université Versailles St-Quentin, Sorbonne Universités, UPMC Univ. Paris 06; CNRS/INSU, Latmos-IPSL, 4 Place Jussieu 75252
Paris Cedex 05 France
Contact : [email protected]
Introduction Methane is the second most important greenhouse gas in the atmosphere after carbon dioxide, but it is 25 times more effective in terms of radiative forcing (IPCC-2007). It plays also an important role in atmospheric ozone chemistry.
Since the pre-industrial times global methane concentrations have more than doubled in the atmosphere, and this increase is generally caused by anthropogenic activities like the massive use and extraction of fossil fuel, rice paddy agriculture and emissions from landfills.
In the Arctic region, methane emissions from thawing permafrost become potentially important due to climate warming and the large carbon pools stored in this region. These emissions are controlled by the temperature, and because methane is a greenhouse gas its
emission could entail positive feedback, so it is very important to monitor and quantify its concentration in the atmosphere in real-time. This study consists of evaluating and quantifying methane strong emissions in the Arctic region using measurements in the TIR from
IASI and TANSO-FTS.
I. Instruments
II. Sensibility of TANSO-FTS and IASI to detect hotspots of CH4 on the surface To study the sensibility of TANSO-FTS and IASI to detect high methane surface emissions, we used simulations from MACC-II (Monitoring Atmospheric Composition and Climate-II) . MACC-II is a high-resolution model (0.125°x0.125°, 137 pressure levels and 3 hours of temporal resolution), it’s based on
TM5-4DVAR inverse modeling system (Bergamashi et al., 2010). MACC-II used satellite retrievals from SCIAMACHY until end of 2011, but since the beginning of 2012 the GOSAT RemoteC PROXY v2.0 XCH4 retrievals have been used. We choose period of high surface methane emission in Canada during 2013 according to the biomass burning emission inventory used by the model.
Maximum of methane between 5 and 10 km was observed on July 6th at
midnight.
We extracted set of methane profiles, which correspond to high values of
methane between 5 and 10 km to simulate their spectra.
To compute this set of spectra, we used LARA algorithm (LATMOS
Atmospheric Retrieval Algorithm).
The temperature profiles, pressure profiles and humidity profiles are
extracted from ECMWF model.
We used the instrumental function of IASI and that of TANSO-FTS to
compute spectra for each instrument.
IASI is capable to detect high values of methane due to a strong methane emissions on the surface.
Conclusion and outlook The results presented in this study show that TANSO-FTS and IASI allow to identify peaks of methane surface emissions with
short duration transported to the layer between 5 and 10 km. We will add noise to our simulated spectra in order to study the ability of LARA algorithm to retrieve profile of methane and then
model to inverse initial emission. In collaboration with LSCE laboratory, we will use the LMDZ-PYVAR to quantify methane emissions in the Arctic region.
As TANSO-FTS, we compute the differences in brightness temperatures between each IASI spectrum simulated with
high values of methane and that with current values of methane, and then we compare the differences in BT to IASI
noise equivalent delta temperature.
The spectral points which correspond to a difference in BT
less than IASI noise do not overlap with methane spectrum.
Acknowledgements We acknowledge our colleagues at LSCE laboratory for their MACC-II data contribution.
References Bergamaschi, P., M. Krol, J. F. Meirink.: Inverse Modeling of European CH4 Emissions 2001–2006, Journal of Geophysical Research: Atmospheres 115(D22): D22309, 2010. C. Clerbaux, A. Boynard, L. Clarisse, M. George, J. Hadji-Lazaro, H. Herbin, D. Hurtmans, M. Pommier,A. Razavi, S. Turquety, C. Wespes, and P.-F. Coheur.: Monitoring of atmospheric composition using the thermal infrared IASI/MetOp sounder, Atmospheric Chemistry and Physics, August 2009. IPCC-2007 (Intergovernmental Panel on Climate Change (2007)), Climate Change 2007: The Physical Sience Basis, edited by S. Solomon et al., Combrige Univ.Press, Cambrige, U.K.
http://www.gosat.nies.go.jp/eng/gosat/page3.htm
IASI
noise 0.1K
Pic of methane by
biomass burning
emission observed
on July 2013 over
Canada
We analyzed data from MACC-II for a 8 days period (from July 1st to 8th ) which correspond to the maximum of surface
methane emission in the set of data.
Strong methane surface emissions
are seen on July 3rd and 4th.
On July 3rd , the emission lasted 12
hours (from 3:00 to 15:00 UTC).
On July 4th, it lasted 9 hours (from
3:00 to 12:00 UTC).
Because the sensibility of IASI and
TANSO-FTS to methane is higher
between 5 and 10 km (and not
close to the surface), we selected
data with high column of methane
between these two layers. Then,
using the extracted methane
profiles, we compute a set of
spectra.
2) IASI /MetOp IASI (Infrared Atmospheric Sounding Interferometer ) is a Fourier transform spectrometer at nadir looking based on a Michelson interferometer coupled to an imaging instrument, designed to measure the spectrum emitted by the earth-atmosphere system in the thermal infrared radiation (TIR).
Spectral resolution : 0.5 cm-1
Spectral coverage : 645 cm-1 – 2760 cm-1
Noise equivalent at 280 K in the spectral range of interest for methane : 0.1K
IASI provides global Earth’s coverage twice a day.
1) TANSO-FTS /GOSAT
TANSO-FTS (Thermal And Near Infrared Sensor for Carbon Observations) is a nadir looking Fourier Transform Spectrometer
that observes sunlight reflected from the earth’s surface and the light emitted from the atmosphere and surface.
Spectral resolution : 0.2 cm-1
Spectral coverage : 3 bands in the SWIR centered at 13158, 6250 and and 5000 cm-1 and one band in the TIR (700 – 1800 cm-1).
TANSO-FTS takes 56 000 measurements covering the globe in 3 days.
C. Clerbaux et al., 2009
To study the capacity of TANSO-FTS and IASI to detect high
values of methane due to strong emissions on the surface, we
compare the differences in brightness temperature between
spectra with high values of methane and that with current
values to the thermal noise of TANSO-FTS and IASI.
C. Clerbaux et al., 2009
A) TANSO-FTS
The spectral points corresponding to a difference in
BT < than TANSO-FTS noise does not overlap with
methane lines.
TANSO-FTS
Noise 0.2K
We computed for each TANSO-FTS simulated spectrum the differences between its brightness temperatures and the
brightness temperatures of the spectrum with current values of methane (spectrum of reference).
We compared the differences in brightness temperature to TANSO-FTS noise equivalent delta temperature.
TANSO-FTS is capable to detect a high values of methane due to a strong methane emissions on the surface.
1) Results :
http://www.gosat.nies.go.jp/eng/gosat/page3.htm
