Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
1 GALLON
NON-IONIC SURFACTANT - ADJUVANT - WETTING AGENT - STICKER - SPREADER - DISPERSANT
INGREDIENTSPrincipal Functioning Agents: Polyethylene glycol mono (branched p-nonylphenyl) ether 18.429%Polydimethylsiloxanes 2.722%Constituents Ineffective as Spray Adjuvants 78.849%TOTAL 100.000%
The ingredients of AgWet 41 are exempt from the requirements of a tolerance under 40 CFR 180.
NOT FOR AQUATIC USE KEEP OUT OF REACH OF CHILDRENWARNINGPRECAUTIONARY STATEMENTS:
WARNINGCauses serious eye irritation. May cause skin irritation. Avoid contact with eyes and skin. Wear protective gloves, clothing and eye/face protection. Wash hands thoroughly after handling. Keep container tightly closed when not in use. FIRST AID: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists, get immediate medical attention. IF SKIN IRRITATION OCCURS: Remove contaminated clothing and wash skin thoroughly with soap and water. If irritation persists, get medical attention. IF SWALLOWED: Do NOT induce vomiting. Rinse mouth and give large quantities of water if victim is conscious. Never give anything by mouth to an unconscious person. If vomiting occurs spontaneously, keep airway open. Get immediate medical attention. IF INHALED: If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing.STORAGE, SPILLS AND DISPOSAL: Store in a cool, dry, well-ventilated area. Keep out of reach of children. Absorb spills with inert absorbent and package into suitable container(s) for disposal. Do not reuse container. Dispose of contents and container in accordance with all federal, state and local regulations.Safety Data Sheet (SDS) available upon request.REGISTRATIONS Idaho, Utah California Registration Number 92735-50001-AAWyoming Registration Number 0140725
GENERAL INFORMATION: AgWet 41 is a non-ionic surfactant, adjuvant, wetting agent, sticker, spreader and dispersant, and can be used with a broad range of equipment. AgWet 41 should be added to a chemical mixture in the order recommended by the chemical manufacturer for a non-ionic surfactant.DIRECTIONS FOR USE:MUST AGITATE BEFORE USINGDO NOT ALLOW PRODUCT TO FREEZEAVERAGE RECOMMENDATIONS FOR MIXING:100 GAL FINAL MIXTURE RATIO
Farm Chemicals 1 - 2 pints 1:800 to 1:400Road Compaction ½ - 1 pint 1:1600 to 1:800Other Products 1 - 3 pints 1:800 to 1:270
The recommendations are considered to be adequate for most uses. Some pesticides, however, may require higher or lower rates for optimum effect. Follow the pesticide(s) label(s) directions when this occurs.
CONDITIONS OF SALE: The buyer or user of this product accepts the following conditions. The user is solely responsible, when mixing with any chemicals, to read and follow mixing instructions of such chemicals. Due to varying conditions, the manufacturer makes no other warranty, expressed or implied, and no agent or seller is authorized to do so. The buyer’s or user’s sole remedy for any injury, loss or damage resulting from the handling or use of this product shall be limited to the purchase price of the product from the manufacturer or replacement of the product and will be the full discharge of the manufacturer’s liability.
Contains Non-Foaming Additive• Non-Corrosive
• Versatile• For Deciduous Trees, Edible Crops, Other Vegetation and Grasses
• Will Not Clog Nozzles• Use Where A Non-Ionic Surfactant is Recommended
INGREDIENTSPrincipal Functioning Agents: Polyethylene glycol mono (branched p-nonylphenyl) ether 18.429%Polydimethylsiloxanes 2.722%Constituents Ineffective as Spray Adjuvants 78.849%TOTAL 100.000%
NON-IONIC SURFACTANT - ADJUVANT - WETTING AGENT - STICKER - SPREADER - DISPERSANT
2 - 2.5 GAL. CASE
The ingredients of AgWet 41 are exempt from the requirements of a tolerance under 40 CFR 180.
Contains Non-Foaming Additive • Non-Corrosive • Versatile • For Deciduous Trees, Edible Crops, Other Vegetation and Grasses • Will Not Clog Nozzles • Use Where A Non-Ionic Surfactant is Recommended
NOT FOR AQUATIC USE KEEP OUT OF REACH OF CHILDRENWARNINGPRECAUTIONARY STATEMENTS:
WARNINGCauses serious eye irritation. May cause skin irritation. Avoid contact with eyes and skin. Wear protective gloves, clothing and eye/face protection. Wash hands thoroughly after handling. Keep container tightly closed when not in use. FIRST AID: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists, get immediate medical attention. IF SKIN IRRITATION OCCURS: Remove contaminated clothing and wash skin thoroughly with soap and water. If irritation persists, get medical attention. IF SWALLOWED: Do NOT induce vomiting. Rinse mouth and give large quantities of water if victim is conscious. Never give anything by mouth to an unconscious person. If vomiting occurs spontaneously, keep airway open. Get immediate medical attention. IF INHALED: If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing.STORAGE, SPILLS AND DISPOSAL: Store in a cool, dry, well-ventilated area. Keep out of reach of children. Absorb spills with inert absorbent and package into suitable container(s) for disposal. Do not reuse container. Dispose of contents and container in accordance with all federal, state and local regulations.Safety Data Sheet (SDS) available upon request.REGISTRATIONS Idaho, Utah California Registration Number 92735-50001-AAWyoming Registration Number 0140725
GENERAL INFORMATION: AgWet 41 is a non-ionic surfactant, adjuvant, wetting agent, sticker, spreader and dispersant, and can be used with a broad range of equipment. AgWet 41 should be added to a chemical mixture in the order recommended by the chemical manufacturer for a non-ionic surfactant.
DIRECTIONS FOR USE:MUST AGITATE BEFORE USINGDO NOT ALLOW PRODUCT TO FREEZE
AVERAGE RECOMMENDATIONS FOR MIXING:100 GAL FINAL MIXTURE RATIOFarm Chemicals 1 - 2 pints 1:800 to 1:400Road Compaction ½ - 1 pint 1:1600 to 1:800Other Products 1 - 3 pints 1:800 to 1:270
The recommendations are considered to be adequate for most uses. Some pesticides, however, may require higher or lower rates for optimum effect. Follow the pesticide(s) label(s) directions when this occurs.
CONDITIONS OF SALE: The buyer or user of this product accepts the following conditions. The user is solely responsible, when mixing with any chemicals, to read and follow mixing instructions of such chemicals. Due to varying conditions, the manufacturer makes no other warranty, expressed or implied, and no agent or seller is authorized to do so. The buyer’s or user’s sole remedy for any injury, loss or damage resulting from the handling or use of this product shall be limited to the purchase price of the product from the manufacturer or replacement of the product and will be the full discharge of the manufacturer’s liability.
275 GALLONS
INGREDIENTSPrincipal Functioning Agents: Polyethylene glycol mono (branched p-nonylphenyl) ether 18.429%Polydimethylsiloxanes 2.722%Constituents Ineffective as Spray Adjuvants 78.849%TOTAL 100.000%
NON-IONIC SURFACTANT - ADJUVANT - WETTING AGENT - STICKER - SPREADER - DISPERSANT
The ingredients of AgWet 41 are exempt from the requirements of a tolerance under 40 CFR 180.
Contains Non-Foaming Additive • Non-Corrosive • Versatile • For Deciduous Trees, Edible Crops, Other Vegetation and Grasses • Will Not Clog Nozzles • Use Where A Non-Ionic Surfactant is Recommended
NOT FOR AQUATIC USE KEEP OUT OF REACH OF CHILDRENWARNINGPRECAUTIONARY STATEMENTS:
WARNINGCauses serious eye irritation. May cause skin irritation. Avoid contact with eyes and skin. Wear protective gloves, clothing and eye/face protection. Wash hands thoroughly after handling. Keep container tightly closed when not in use. FIRST AID: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists, get immediate medical attention. IF SKIN IRRITATION OCCURS: Remove contaminated clothing and wash skin thoroughly with soap and water. If irritation persists, get medical attention. IF SWALLOWED: Do NOT induce vomiting. Rinse mouth and give large quantities of water if victim is conscious. Never give anything by mouth to an unconscious person. If vomiting occurs spontaneously, keep airway open. Get immediate medical attention. IF INHALED: If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing.STORAGE, SPILLS AND DISPOSAL: Store in a cool, dry, well-ventilated area. Keep out of reach of children. Absorb spills with inert absorbent and package into suitable container(s) for disposal. Do not reuse container. Dispose of contents and container in accordance with all federal, state and local regulations.Safety Data Sheet (SDS) available upon request.REGISTRATIONS Idaho, Utah California Registration Number 92735-50001-AAWyoming Registration Number 0140725
GENERAL INFORMATION: AgWet 41 is a non-ionic surfactant, adjuvant, wetting agent, sticker, spreader and dispersant, and can be used with a broad range of equipment. AgWet 41 should be added to a chemical mixture in the order recommended by the chemical manufacturer for a non-ionic surfactant.
DIRECTIONS FOR USE:MUST AGITATE BEFORE USINGDO NOT ALLOW PRODUCT TO FREEZE
AVERAGE RECOMMENDATIONS FOR MIXING:100 GAL FINAL MIXTURE RATIOFarm Chemicals 1 - 2 pints 1:800 to 1:400Road Compaction ½ - 1 pint 1:1600 to 1:800Other Products 1 - 3 pints 1:800 to 1:270
The recommendations are considered to be adequate for most uses. Some pesticides, however, may require higher or lower rates for optimum effect. Follow the pesticide(s) label(s) directions when this occurs.
CONDITIONS OF SALE: The buyer or user of this product accepts the following conditions. The user is solely responsible, when mixing with any chemicals, to read and follow mixing instructions of such chemicals. Due to varying conditions, the manufacturer makes no other warranty, expressed or implied, and no agent or seller is authorized to do so. The buyer’s or user’s sole remedy for any injury, loss or damage resulting from the handling or use of this product shall be limited to the purchase price of the product from the manufacturer or replacement of the product and will be the full discharge of the manufacturer’s liability.