Manual Cambio de Lamparas Interiores

8/11/2019 Manual Cambio de Lamparas Interiores

1/13


2/13


3/13

LIGHTING SYSTEMS

09-18101

8. Remove the front map light bulb.9. Install in the reverse order of removal.

Rear Map L ight

DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)2. To prevent scratches or damage, affix protective tape to the position shown in the figure.

Caut ionIf a flathead screwdr iver is inserted into the gap between the rear map l ight and lens, the rear maplight could interfere w ith the flathead screwdr iver result ing in damage to the rear map l ight . Whenremov ing the lens from the rear map l ight, perform the procedure after aff ix ing protect ive tape tothe rear map l ight .

FRONT MAP LIGHT BULB

ac5wzw0000005

PROTECTIVE TAPE

REAR MAP LIGHT

ac5wzw0000047

TO MODEL INDEXACK TO CHAPTER INDEX

1. Disconnect the negative battery cable. (See 01-17A-13 NEGATIVE BATTERY CABLE DISCONNECTION/ CONNECTION [SKYACTIV-G 2.0 (WITHOUT i-stop)].) (See 01-17A-11 NEGATIVE BATTERY CABLEDISCONNECTION/CONNECTION [SKYACTIV-G 2.0].) (See 01-17B-9 NEGATIVE BATTERY CABLE

MAZDA CX5 WORKSHOP REPAIR MANUAL
http://front_page.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual1197.pdf/http://mazda_cx5_workshop_manual1197.pdf/http://mazda_cx5_workshop_manual1197.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1197.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://front_page.pdf/http://mazda_cx5_workshop_manual4356.pdf/http://mazda_cx5_workshop_manual4358.pdf/http://mazda_cx5_workshop_manual4358.pdf/http://mazda_cx5_workshop_manual4356.pdf/


4/13

09-18102

LIGHTING SYSTEMS

3. Press the lens to secure a sufficient space forinserting a flathead screwdriver.

4. Insert a tape-wrapped flathead screwdriver intothe gap between the lens and rear map lightshown in the figure.

5. Move the flathead screwdriver in the direction ofthe arrow (1) shown in the figure, pull out the lensfrom the rear map light, and detach the rear maplight pin and lens.

6. Remove the lens.

VEHICLE HI LFRONT

VEHICLEFRONT

FLATHEAD SCREWDRIVERINSERTION HOLE

LENS

ac5wzw0000119

VEHICLE HI LFRONT

VEHICLEFRONT

FLATHEAD SCREWDRIVER

LENS

ac5wzw0000047

VEHICLE HI LFRONT

VEHICLEFRONT

VEHICLE HI LFRONT

VEHICLEFRONT

PIN


(1)

LENS

ac5wzw0000047

LENS REAR MAP LIGHTac5wzw0000047

TO MODEL INDEXACK TO CHAPTER INDEX MAZDA CX5 WORKSHOP REPAIR MANUAL
http://front_page.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://front_page.pdf/http://mazda_cx5_workshop_manual4357.pdf/http://mazda_cx5_workshop_manual4359.pdf/http://mazda_cx5_workshop_manual4359.pdf/http://mazda_cx5_workshop_manual4357.pdf/


5/13

LIGHTING SYSTEMS

09-18103

7. Move the rear map light spring in the direction ofthe arrow (2) shown in the figure and detach therear map light spring and rear map light bulb.

8. Remove the rear map light bulb.9. Install in the reverse order of removal.

End Of Sie

MAP LIGHT INSPECTIONid091800801300

Front Map L ight

2. Verify that the continuity between the front map light terminals is as indicated in the table.

2(2)2(2)

REAR MAP LIGHT BULBSPRINGSPRING

ac5wzw0000120

REAR MAP LIGHT BULB

ac5wzw0000048

ABCDEFGH

F

ON OFF

FRONTMAP LIGHTSWITCH(RH)

FRONTMAP LIGHTSWITCH(LH)

ROOMLIGHTSWITCH

H

ON OFF ON OFF

DOOR

A G

ac5wzw0000001


1. Remove the front map light. ( See 09-18-95 MAP LIGHT REMOVAL/INSTALLATION.)

http://front_page.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://mazda_cx5_workshop_manual4351.pdf/http://mazda_cx5_workshop_manual4351.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://front_page.pdf/http://mazda_cx5_workshop_manual4358.pdf/http://mazda_cx5_workshop_manual4360.pdf/http://mazda_cx5_workshop_manual4360.pdf/http://mazda_cx5_workshop_manual4358.pdf/


6/13


7/13


8/13

09-18106

LIGHTING SYSTEMS

5. Remove the cargo compartment light.

6. Disconnect the connector.7. Install in the reverse order of removal.

End Of Sie

CARGO COMPARTMENT LIGHT BULB REMOVAL/INSTALLATIONid091800807800

DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)2. To prevent scratches or damage, affix protective tape to the position shown in the figure.

Caut ionIf a flathead screwdr iver is inserted into the gap between the cargo compartment l ight and trunks ide tr im, the trunk s ide tr im could interfere w ith the flathead screwdr iver and be damaged . Whenremov ing the cargo compartment l ight from the trunk s ide tr im, perform the procedure afteraff ix ing protect ive tape to the trunk s ide tr im .

CARGO COMPARTMENT LIGHT

ac5wzw0000042

CONNECTOR CARGO COMPARTMENT LIGHT

ac5wzw0000002

PROTECTIVE TAPE


ac5wzw0000003



http://front_page.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual1197.pdf/http://mazda_cx5_workshop_manual1197.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1197.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://front_page.pdf/http://mazda_cx5_workshop_manual4361.pdf/http://mazda_cx5_workshop_manual4363.pdf/http://mazda_cx5_workshop_manual4363.pdf/http://mazda_cx5_workshop_manual4361.pdf/


9/13

LIGHTING SYSTEMS

09-18107

3. Insert a tape-wrapped flathead screwdriver intothe gap between the cargo compartment light andtrunk side trim shown in the figure.

4. Move the flathead screwdriver in the direction ofthe arrow (1) shown in the figure, pull out thecargo compartment light from the trunk side trim,and detach the cargo compartment light tab andtrunk side trim.

5. Remove the cargo compartment light.

6. Press the cargo compartment light spring in thedirection of the arrow (2) shown in the figure anddetach it and the cargo compartment light bulb.

FLATHEADSCREWDRIVERCARGO COMPARTMENT LIGHT

ac5wzw0000004

TAB

FLATHEADSCREWDRIVER

(1)

CARGO COMPARTMENTLIGHT

LIFTGATESIDE TRIM

VEHICLE FRONT

ac5wzw0000004


ac5wzw0000046

CARGO COMPARTMENT LIGHT BULB

(2)2(2)

SPRING

ac5wzw0000119

http://front_page.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://front_page.pdf/http://mazda_cx5_workshop_manual4362.pdf/http://mazda_cx5_workshop_manual4364.pdf/http://mazda_cx5_workshop_manual4364.pdf/http://mazda_cx5_workshop_manual4362.pdf/


10/13

09-18108

LIGHTING SYSTEMS

7. Remove the cargo compartment light bulb.8. Install in the reverse order of removal.

End Of Sie

CARGO COMPARTMENT LIGHT INSPECTIONid091800801800

INSTALLATION.)2. Verify that the continuity between the cargo

compartment light terminals is as indicated in thetable.

If not as indicated in the table, replace the

CARGO COMPARTMENT LIGHT REMOVAL/ INSTALLATION.)

End Of Sie

GLOVE COMPARTMENT LIGHT BULB REMOVAL/INSTALLATIONid091800801900

DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)2. Open the glove compartment.

CARGO COMPARTMENT LIGHT BULB


ac5wzw0000004

AB

B

A

ac5wzw0000002

Term inal

A B

On

Off

Sw itch pos it ion

: Bulb

ac5wzw0000042


1. Remove the cargo compartment light. (See 09-18-105 CARGO COMPARTMENT LIGHT REMOVAL/

cargo compartment light. (See 09-18-105


http://front_page.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://mazda_cx5_workshop_manual4361.pdf/http://mazda_cx5_workshop_manual4361.pdf/http://mazda_cx5_workshop_manual4361.pdf/http://mazda_cx5_workshop_manual4361.pdf/http://mazda_cx5_workshop_manual4361.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual1197.pdf/http://mazda_cx5_workshop_manual1197.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1222.pdf/http://mazda_cx5_workshop_manual1197.pdf/http://mazda_cx5_workshop_manual1199.pdf/http://mazda_cx5_workshop_manual4361.pdf/http://mazda_cx5_workshop_manual4361.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://front_page.pdf/http://mazda_cx5_workshop_manual4363.pdf/http://mazda_cx5_workshop_manual4365.pdf/http://mazda_cx5_workshop_manual4365.pdf/http://mazda_cx5_workshop_manual4363.pdf/


11/13

LIGHTING SYSTEMS

09-18109

3. While pressing the glove compartment light tab in the direction of the arrow (1) shown in the figure, pull out theglove compartment light in the direction of the arrow (2) shown in the figure to detach the glove compartmentlight tab and lower panel.

4. Remove the glove compartment light.

5. Remove the glove compartment light bulb.6. Install in the reverse order of removal.

End Of Sie

VANITY MIRROR ILLUMINATION INSPECTIONid091800808500

DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

FRONT

TAB

(1) (1) (2)

LEFT

GLOVE COMPARTMENT LIGHT

LOWER PANEL

ac5wzw0000002

GLOVE COMPARTMENT LIGHT

ac5wzw0000042

GLOVE COMPARTMENTLIGHT BULB

SOCKET

ac5wzw0000002



2. Remove the sunvisor. ( See 09-17-93 SUNVISOR REMOVAL/INSTALLATION.)



12/13

09-18110

LIGHTING SYSTEMS

3. Verify that the continuity between the vanity mirrorillumination terminals is as indicated in the table.

If not as indicated in the table, replace the

REMOVAL/INSTALLATION.)End Of Sie

VANITY MIRROR ILLUMINATION BULB REMOVAL/INSTALLATIONid091800808200

DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure.

AB

B

A

ac5wzw0000004

Term inal

A B

Open

Close

Van ity m irror covercond ition

: Bulb

ac5wzw0000046

SUNVISOR

SERVICE HOLE

ac5wzw0000012



sunvisor. ( See 09-17-93 SUNVISOR



13/13

LIGHTING SYSTEMS

09-18111

3. Move a flathead screwdriver in the direction of the arrow (1) shown in the figure and detach the lens tab andsunvisor.

4. Detach all the lens tab and sunvisor and removethe lens from the sunvisor.

5. Remove the vanity mirror illumination bulb.6. Install in the reverse order of removal.

End Of Sie


LENS

(1)

SUNVISOR

LENS

TAB

TAB

ac5wzw0000012

SUNVISOR

LENS

ac5wzw0000046

SUNVISOR

VANITY MIRROR ILLUMINATION BULB

ac5wzw0000012

http://front_page.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://mazda_cx5_workshop_manual4257.pdf/http://front_page.pdf/http://mazda_cx5_workshop_manual4368.pdf/http://mazda_cx5_workshop_manual4366.pdf/

Documents

Manual Cambio de Lamparas Interiores