Embed Size (px)
Citation preview
KAPAGEN INPUT and OUTPUT Powerby Jean-Louis Naudin
created on may 28, 2010 - JLN Labs - Last update July 2nd, 2010Toutes les informations et schémas sont publiés gratuitement ( freeware ) et sont destinés à un usage
personnel et non commercialAll informations and diagrams are published freely (freeware) and are intended for a private use and a non
commercial use.
The purpose of this test is to measure with more accuracy the INPUT electrical power of the Kapagen v3.3. There are 14 x 150 W halogen lamps connected in serie at the output of the Kapagen. I have used a Voltcraft LX-1108 Luxmeter to measure the light intensity of one of these lamps Vs the electrical power required, a calibration curve has been set.
The total OUPUT power for the 14 halogen lamps is calculated with the calibration sheet, below.
To measure the electrical INPUT POWER, I have used the high end energy meter Voltcraft Energy Logger 4000F connected at the output
of the variac.
The electrical ground conditions were very poor due to the dryness. I have added water to the ground points to improve the conductivity.
The Kapagen v3.3 Power IO results are below:
Email : [email protected]
return to Kapagen project page
visitors since May 28, 2010
