Installing a double Dreamscreen Slide 2 Check measurement Left
Slide 3 Center Slide 4 and right Slide 5 Check your Dreamscreen Be
sure that the Dreamscreen you ordered is the right size for the
opening. Be sure that the Dreamscreen you ordered is the right size
for the opening. Lets move on with the installation Lets move on
with the installation Slide 6 Lets open the boxes. Inside the right
door box, there should be a dreamscreen and the top and bottom
track. Inside the right door box, there should be a dreamscreen and
the top and bottom track. Inside the left door box, there should be
a dreamscreen, and a screw pack and a set of specially designed
stop pins. Inside the left door box, there should be a dreamscreen,
and a screw pack and a set of specially designed stop pins. Any
other options purchased will also be in one of the boxes. Slide 7
Right Door, clear wrapping on ends Left Door, Blue wrapping on ends
Screw pack Tracks, top and bottom, wrapped together Stop Pins now
included in all double Dreamscreens Slide 8 Contents of the Double
Door Screw Pack. This is all you need to install a dreamscreen 4
#10 phillips screws Top track support And screw (optional) Spring
tension tool. (This is not needed for custom sized screens) Stop
Pin Hardware Slide 9 Tracks Top Bottom Notice the 45% notch on the
back of the top track FRONT Slide 10 Installation Here, we check
the sill for levelness. Slide 11 Here, the installer uses one
method to check for squareness. Slide 12 Note Dreamscreens do not
have to be level or plumb but they do have to be square.
Dreamscreens do not have to be level or plumb but they do have to
be square. ok Not ok Slide 13 Prep Here, the installer sets himself
up to begin Slide 14 Set the first door up Insert screw and half
tighten - just enough to hold Slide 15 Repeat on other side
Remember to not tighten the screw, just enough to hold Slide 16
Measure for the tracks From here To here Measure exact from housing
to housing Slide 17 Repeat at the bottom Compare the two
measurements. Slide 18 Very Important! The top and the bottom track
must be the exact same length. If they are not, the dreamscreen
will not operate properly The top and the bottom track must be the
exact same length. If they are not, the dreamscreen will not
operate properly If these measurements are not the same, use the
smaller of the two measurements as your track size. If these
measurements are not the same, use the smaller of the two
measurements as your track size. Slide 19 Mark out the tracks.
Slide 20 Make the cut Remember to cut both tracks the exact same
size Slide 21 After cutting tracks.. Re-cut the 45% angle on the
freshly cut end Only on the back not the front Slide 22 Install the
track Slide track through plastic guide and onto the brass clip
Track fits onto clip Slide 23 Track snug against housing Slide 24
Repeat on other side Remove the screw to pull the housing out
enough to fit track Slide 25 Track fits through guide Slide 26
Through guide and onto clip Slide 27 Fit bottom track same as the
top Slide 28 Repeat for other side Remove the screw to pull housing
out Slide 29 Through guide and onto clip Slide 30 Rail snug against
housing Slide 31 It should look like this. Slide 32 Make sure it is
square Use a carpenters square and make sure the unit is square. If
it isnt, make adjustments until it is. Slide 33 Now you can tighten
the screws Slide 34 Lubricate the tracks Pure silicone only where
guides meet the tracks Slide 35 Never use WD-40 Use pure clear
Silicone only On your Dreamscreen Slide 36 Cycle the door Slide 37
Thats it You have installed a double Dreamscreen.
