Upload
others
View
9
Download
0
Embed Size (px)
Citation preview
Almond (SACMAD)
Grigio (SACMGO)
Travertine is eternal. It was popular in Ancient Rome and is still a prevalent and attractive look today. With the Colosseum series, Savoia uses modern technology to make a fresh, realistic travertine-look with all the advantages of glazed porcelain.
(24A)
Colors are intended as a guide only and may vary from actual tile. Sizes listed are nominal. Please check samples before making final selection and to get actual dimensions for layout.
MADE IN ITALY
Beige (SACMBE)
COLOSSEUM
13 x 13
13 x 13
13 x 13
12 x 24
12 x 24
12 x 24
Mosaic
Mosaic
Mosaic
SACM--/SBN 3 x 13 Surface Bullnose
If installing a running bond a 1/3 maximum offset is recommended. Please refer to ANSI requirements for setting large format tiles (ANSI A 108.2 Section 4.3.8.) There are special setting requirements and materials for large format tiles. Please refer to the TCNA Handbook and guidelines by your mortar manufacturer for more information.
It is important to work with the layout, mixing pieces within each carton and pulling from several cartons, to get the proper blend during installation. Due to the different production techniques and times, expect variation in size and color between field and trim.
Sizes (non-rectified)
ColorsProduct Information
SACMAD Colosseum AlmondSACMBE Colosseum BeigeSACMGO Colosseum Grigio
Usage
Coordinating Trim
The surface bullnose is made from field tile that is cut, ground and reglazed.
Installation Information
Trim
SACM--/1313 13 x 13SACM--/1224 12 x 24SACM--/33 3 ¼ X 3 ¼ Mosaic
Mosaic is mounted on approximate 13 x 13 sheets.
TSSACM/170124
** These results are for the natural finish and for the normal productions; if there is concern about a particular production, it should be tested. The Coefficient of Friction is a general guide only. Testing may vary with different production runs and with different testing labs.
As noted in the Americans with Disabilities Act (ADA) the coefficient of friction varies considerably due to facts not under the control of entities such as the manufacturers and distributors. These factors include, but are not limited to, contaminants, slope of terrain, drainage conditions, adjacent surfaces, etc. Suitability for any installation can only be determined by a site examination of all conditions that could affect the slip resistance of the tile being installed. Continual cleaning and maintenance must be performed once the tile has been installed. For more information see our current handout Americans with Disabilities Act and Slip Resistance of Tile.
Colosseum is suitable for use on walls, counters and residential to light duty commercial floors.
SACM--/A113 13” Quarter RoundSACM--/AC113 Beak
≤ 0,05
DCOF
10545-12
10545-03
10545-04
10545-04
Wet ≥ 0.42
Compliant
PEI IV
No Damage
45,5 N/mm2 (average value)
Breaking Strength
Dynamic (DCOF)Coefficient of Friction
Average Bending Strength
Water Absorption
Frost Resistance
**
DIN51130Abrasion Resistance