Embed Size (px)
DESCRIPTION
Vertical solids handling pump for normal and difficult liquids. The EGGER Cantilever pump model “SO” is designed with a heavy-duty gearbox which sits above the pumped liquid. A large diameter shaft is used to transfer the power to the submerged pump impeller. The “SO” design removes all bearings and seals from the process fluid and allows for continuous dry running operation. Ideal for abrasive slurries since there are no mechanical seals or bearings exposed to the process fluid.
Citation preview
Wastewater Sludge Applications Material of Construction
Cantilever PumpsDesign SO/SOK, Series T/E/EO/EOSVertical solids handling pump for normal and difficult liquids.
Abrasion resistant construction
• ASTM 536 White Iron materials
• 316 stainless steel shaft sleeve
• INPROSEAL labyrinth bearing
isolators
Special materials available
Cast iron, ductile iron, stainless
steel, duplex, titanium, Hastelloy
C, and other special materials
upon request
Available sizes
• Size: 1 1/4 to 8 inch
• Flows: 20 to 2220 gpm
• Differential Head: up to 460 feet
• Pressures: up to 440 psig
• Temperatures: up to 355 deg. F
The EGGER Cantilever pump model “SO” is designed with a heavy-duty gearbox which sits above the pumped liquid. A large diameter shaft is used to transfer the power to the submerged pump impeller.
The “SO” design removes all bearings and seals from the process fluid and allows for continuous dry running operation.
Ideal for abrasive slurries since there are no mechan-ical seals or bearings exposed to the process fluid.
NO BEARINGS+ NO SEALS
= NO MAINTENANCE!
✓ Primary
✓ Digester feed
✓ Digester recirculation
✓ Return Activated Sludge
✓ Waste Activated Sludge
✓ Thickened Waste Activated
✓ Supernatant
✓ Scum
✓ Grit
✓ Imported
✓ Centrifuge feed
✓ Belt press feed
The Turo Advantage
Superior Hydraulic Efficiency • Lower cost of ownership • Twice our competitors efficiency • ½ half the horsepower
Fully Recessed “Vortex” Impeller • 85% of the fluid never comes in contact with the impeller • Less Wear, Less Shear • Full port solids handling • Non-clog impeller design
Designed “NOT” to wear • Axial Spiral Casing design helps channel flow thru pump and reduce wear causing recirculation • Fully Recessed – 85% of fluid never contacts impeller • Impeller is centered in casing to reduce radial thrust loads • Smaller “cut-water” helps to balance radial thrusts
Maintenance friendly rear pull-out design • Allows easy removal of bearing frame without disconnecting the suction or discharge piping.
Performance Range Turo® T 60 Hz / n = 1750 min-1 60 Hz / n = 1160 min-1
Further information can be found on: www.eggerpumps.com
North America
P.O. Box 26787Salt Lake City, UT 84126Phone (801) 972-9591
EGGER TURO PUMPS North America, Inc.
Installation
SODry (tank) installationPump fitted outside of tank. Suction and drainage pipes connected to suction tank. Bearing housing and motor arranged above max. liquid level.
SOWet pit installationThe pit-cover is above the bearing housing. This allows a deeper installation length ETo.
SOKWet pit installationIdentical to SO, with shorter installation length.
SOWet pit installationPump end submerged in medium to be pumped. Bearing housing and motor arranged above max. liquid level.
