ATLAS End-Cap C ATLAS End-Cap C Proposed Transport BoxProposed Transport Box

P CookeP Cooke

15 June 200515 June 2005

RequirementsRequirements

Support using transport frame onlySupport using transport frame only Isolate Thermal plug from transport boxIsolate Thermal plug from transport box Temperature controlled truckTemperature controlled truck Rear door opening - 2.7M high x 2.45M Rear door opening - 2.7M high x 2.45M

widewide Load onto truck with fork-liftLoad onto truck with fork-lift Recommended transport company - Recommended transport company -

DanzasDanzas

MethodMethod

Raise end-cap assembly frame 225mm Raise end-cap assembly frame 225mm to clear lowest point of transport frame to clear lowest point of transport frame

Necessary to remove assembly frame Necessary to remove assembly frame floor (reducing supported weight)floor (reducing supported weight)

Lower transport frame 90mm (extend Lower transport frame 90mm (extend wheel brackets)wheel brackets)

Manufacture strong palletManufacture strong pallet Construct protective frame and box onto Construct protective frame and box onto

palletpallet

Original Assembly/Transport frames

Assembly frame raised 225mm and wheels raised

90mm

Inner Protective Frame assembled from Bosch Profile

Inner frame covered with varnished 12mm ply-wood

Top and Underside views of steel pallet

Assembly positioned over pallet

Wheels transferred onto pallet

Outer frame assembled using Bosch profile attached to

pallet

Outer frame covered with 25mm varnished ply-wood

Cut-away section of complete assembly