Embed Size (px)
DESCRIPTION
Assembly Instructions
Citation preview
E4P Assembly Instructions
page11400 NE 136th Ave. Vancouver, Washington 98684 USA
Local: 360.260.2468 Sales: 800.736.0194Support: 360.397.9999 Fax: 360.260.2469
[email protected] www.usdigital.com
1. Base Mounting
4. Cover InstallationPlace housing (cover) on. With thumb and finger,squeeze ears together to insure that cover fullylatches.
Place base over shaft. Secure base to mountingsurface using two screws.
Transfer Adhesive: Peel off paper backing, placecentering tool into center hole of base, slip centeringtool onto shaft and slide base and centering tool downonto mounting surface as one piece. Press to form agood bond, then slip centering tool off shaft andcontinue with standard mounting instructions.
3. Hub Disk Assembly InstallationPosition spacer / installation tool onto hub disk assem-bly. Spacer / installation tool provides an air gap of0.07" ±0.03". Press down firmly until tool bottoms outon base latching ears.
2. Hub Disk Assembly PlacementPlace hub disk assembly onto shaft with pattern-sidedown towards base.
