Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
ANGULAR JOINTAssembly Guide
RGKit ACCESSORIES
3
x2 x2x2 x2 x7
x2
x3
4
Tips and Tricks
When you use Joint to mount Angular make sure to follow those tips and tricks.
1. Use Angular Elevated Mounting option.
2. Place Angular as close to the corner as possible.
3. It’s preferable to use it with a design that moves sideways, and not up and down, to avoid the weight load on Angular. The design should be on hinges.
5
Your Design/Door
6
1.
Apply White Glue
7
Wait until the white glue dries. The duration depends on the instructions on your glue.
8
2.
9
3.
10
4.
11
5.
12
6.
7.
14
8.
Make sure that Joint is not fastened too tight or too loose. The parts should be able to move freely without falling apart.
16
9.
17
10.
18
11.
19
12.
20
13.
Open the design/door to the maximum, and mark where the screw is. Make sure the angle is more than 90 degrees and less than 180, and that there is minimal distance between Angular and the axis your design will pivot on.
21
Your Design/Door
22
13.
Your Design/Door
RGKit Accessories V 2.0Designed by Argineering. Cairo, Egypt.©2019 Argineering. All rights reserved.
argineering.net