Installation of Ranger Proof Edge Glock Trigger

THIS INSTALLATION IS TO BE COMPLETED BY AN EXPERIENCED GUNSMITH OR ARMORER. THESE

INSTRUCTIONS ARE PROVIDED AS GUIDE FOR GUNSMITHS AND ARMORERS TO ENSURE SAFE AND

CORRECT INSTALLATION OF THE EDGE TRIGGER.

TOOLS NEED

• 1/16” Steel Pin Punch

• Hammer

• Small Wood Block or Armorers Block

STEP 1

• Ensure the firearm is unloaded and safe. Remove all ammunition from the work area!

• Field Strip and disassemble weapon as per Glock manual.

• Remove the trigger bar

• On the left side of the OEM trigger, locate exposed pin. This is the pin you will remove.

STEP 2

• Use Pin Punch and Hammer to push the pin through the opposite side of the plastic trigger

• Be sure to keep the bar FLAT in order to not bend or warp the bar. Any bend or warp in the bar may result in the trigger or weapon not working properly.

STEP 3

• Remove the plastic trigger from your trigger bar

• Insert trigger bar into Ranger Proof Edge Trigger.

• Insert supplied pin into the RIGHT side of the Trigger.

• Using a firm and flat surface, tap lightly with hammer to seat pin in trigger.

• Pin should be flush with trigger surface

STEP 4

• Trigger is now assembled

• Reassemble your pistol as per Glock Manual.

• Enjoy the new enhanced feel of your Ranger Proof Edge Glock Trigger

RANGERPROOFSWAG.COM

©RANGER PROOF SWAG, LLC 2017 ALL RIGHTS RESERVED