Model 6 Bender Setup

7/29/2019 Model 6 Bender Setup

http://slidepdf.com/reader/full/model-6-bender-setup 1/1

Crush bend tooling is used primarily for bending thinwall tubing to a tight radius. If it is not necessary for

the formed section to retain its original shape, such as

in structural components, the tubing can be uniformly

indented with this tooling. The "crush" on the inside radius

adds additional strength to the bend, as well as allowing a

tight radius with controlled distortion in the bend area.

Rotating Arm

Center Pin

Toggle Clamp for securing material

Toggle Clamp for supporting Follow Block 

“CRUSH-BEND” TOOLING FOR FORMING SQUARE TUBE

Holding Pin

>

>

NO6BENDERSETUP

4

Model 6 Setup - For bending TUBING, ANGLE AND CHANNEL. Includesclamps and pressure roller assembly as basic tooling for tube bending.

No. 6 Bender ToolingStandard Grooved Collar - for bending

round tubing. Used with Clamp Block 

and Follow Block.

When bending materials of open cross section such

as tubing, channel, angle and extrusions, the bending

form should exactly fit the contour of the material to

provide support during the forming operation. This

is also true of the Clamp Block and Pressure Tool as

only completely confining the material can a good

bend be obtained.

 O p t i o na l  b e n

 d e r 

 t o o l i n g  ca n  b e 

 f o u n d 

 o n  pa g e s  7 -11

.

Special Crush Bend Tooling for Round

and Square Tubing - designed for both 6

POWER and 8 POWER benders.