Upload
visiondesign
View
215
Download
0
Embed Size (px)
Citation preview
7/29/2019 Model 6 Bender Setup
http://slidepdf.com/reader/full/model-6-bender-setup 1/1
Crush bend tooling is used primarily for bending thinwall tubing to a tight radius. If it is not necessary for
the formed section to retain its original shape, such as
in structural components, the tubing can be uniformly
indented with this tooling. The "crush" on the inside radius
adds additional strength to the bend, as well as allowing a
tight radius with controlled distortion in the bend area.
Rotating Arm
Center Pin
Toggle Clamp for securing material
Toggle Clamp for supporting Follow Block
“CRUSH-BEND” TOOLING FOR FORMING SQUARE TUBE
Holding Pin
>
>
NO6BENDERSETUP
4
Model 6 Setup - For bending TUBING, ANGLE AND CHANNEL. Includesclamps and pressure roller assembly as basic tooling for tube bending.
No. 6 Bender ToolingStandard Grooved Collar - for bending
round tubing. Used with Clamp Block
and Follow Block.
When bending materials of open cross section such
as tubing, channel, angle and extrusions, the bending
form should exactly fit the contour of the material to
provide support during the forming operation. This
is also true of the Clamp Block and Pressure Tool as
only completely confining the material can a good
bend be obtained.
O p t i o na l b e n
d e r
t o o l i n g ca n b e
f o u n d
o n pa g e s 7 -11
.
Special Crush Bend Tooling for Round
and Square Tubing - designed for both 6
POWER and 8 POWER benders.