ENGINE IGNITION - V8 5.0L PETROL/V8 S/C 5.0L PETROL ... · 12/29/1993  · Refer to: Battery...

2010.0 XF (X250), 303-07

ENGINE IGNITION - V8 5.0L PETROL/V8 S/C 5.0L PETROL

IGNITION COIL-ON-PLUG - V8 S/C 5.0L PETROL (G1085794)

REMOVAL AND INSTALLATION

18.20.36

ON PLUG IGNITION

COIL - RENEW

4200 CC, AJ V8,

NATURALLY ASPIRATED

0.2USED

WITHINS

18.20.36

ON PLUG IGNITION

COIL - RENEW

5000 CC, AJ V8,

NATURALLY ASPIRATED

1USED

WITHINS

18.20.36

ON PLUG IGNITION

COIL - RENEW

5000 CC, AJ V8,

SUPERCHARGED1.1

USED WITHINS

18.20.40

ON-PLUG IGNITION

COIL - ENGINE SET - RENEW

3000 CC, AJ-V6

1.2USED

WITHINS

18.20.40

ON-PLUG IGNITION

COIL - ENGINE SET - RENEW

4200 CC, AJ V8,

NATURALLY ASPIRATED

0.6USED

WITHINS

18.20.40

ON-PLUG IGNITION

COIL - 5000 CC, AJ V8,

NATURALLY 2.1

USED WITHINS

ENGINE SET - RENEW

ASPIRATED

18.20.40

ON-PLUG IGNITION

COIL - ENGINE SET - RENEW

5000 CC, AJ V8,

SUPERCHARGED2.2

USED WITHINS

NOTES:

REMOVAL

Removal steps in this procedure may contain installation

details.

Some variation in the illustrations may occur, but the essential

information is always correct.

Refer to: (414-01 Battery, Battery Disconnect and Connect

Mounting and Cables, General Procedures).

1.

Refer to: Engine Cover - V8 5.0L Petrol/V8 S/C 5.0L Petrol

(501-05 Interior Trim and Ornamentation, Removal and

Installation).

2.

Refer to: Secondary Bulkhead Panel RH - TDV6 3.0L Diesel

(501-02 Front End Body /V8 5.0L Petrol/V8 S/C 5.0L Petrol

Panels, Removal and Installation).

3.

4.

CAUTIONS:

Be prepared to collect escaping coolant.

Make sure that all openings are sealed. Use new

blanking caps.

5.

6.

2010.0 XF (X250), 501-02

FRONT END BODY PANELS

SECONDARY BULKHEAD PANEL RH - TDV6 3.0L DIESEL /V8 5.0L PETROL/V8 S/C 5.0L PETROL (G1090271)

Torque: 7 Nm

INSTALLATION

To install, reverse the removal procedure.1.

REMOVAL AND INSTALLATION

76.11.30

ENGINE COMPARTMENT RIGHT HAND

COVER - RENEW

3000 CC, AJ-V6

0.9USED

WITHINS

76.11.30

ENGINE COMPARTMENT RIGHT HAND

COVER - RENEW

3000 CC, TDV6

0.9USED

WITHINS

76.11.30

ENGINE COMPARTMENT RIGHT HAND

COVER - RENEW

5000 CC, AJ V8

0.9USED

WITHINS

NOTE:

REMOVAL

Removal steps in this procedure may contain installation details.

All vehicles

Refer to: (501-02 Front End Secondary Bulkhead Center Panel

Body Panels, Removal and Installation).

1.

Torque: 25 Nm

2.

Right-hand drive vehicles

NOTE:1.

Some variation in the illustrations may occur, but the

essential information is always correct.

Left-hand drive vehicles

1.

NOTE:2.

Some variation in the illustrations may occur, but the

essential information is always correct.

Vehicles with 5.0L

Refer to: (303-12C Intake Air Distribution and Air Cleaner RH

Filtering - V8 5.0L Petrol, Removal and Installation).

1.

Vehicles with diesel engine

1.

All vehicles

1.

2.

INSTALLATION

2010.0 XF (X250), 501-05

INTERIOR TRIM AND ORNAMENTATION

ENGINE COVER - V8 5.0L PETROL/V8 S/C 5.0L PETROL (G1090386)

To install, reverse the removal procedure.1.

REMOVAL AND INSTALLATION

12.29.93ENGINE COVER - RENEW

3000 CC, TDV6

0.1USED

WITHINS

12.29.93ENGINE COVER - RENEW

4200 CC, AJ V8,

NATURALLY ASPIRATED

0.1USED

WITHINS

12.29.93ENGINE COVER - RENEW

5000 CC, AJ V8

0.1USED

WITHINS

NOTE:

REMOVAL

Removal steps in this procedure may contain installation details.

1.

2010.0 XF (X250), 414-01

BATTERY, MOUNTING AND CABLES

BATTERY DISCONNECT AND CONNECT (G1033944)

NOTE:

Some variation in the illustrations may occur, but the

essential information is always correct.

INSTALLATION

To install, reverse the removal procedure.1.

BATTERY DISCONNECT AND CONNECT (G1033944)

GENERAL PROCEDURES

NOTE:

DISCONNECT

If a new battery is installed, the battery monitoring system

(BMS) must be reset using Jaguar approved diagnostic

equipment.

Refer to: Battery and Battery Charging Health and Safety

(100-00 General Information, Description and Precautions

Operation).

1.

Obtain and record the audio unit preset radio frequencies.2.

3.

NOTE:4.

Where fitted.

CAUTION:

Take extra care not to damage the wiring harness.

5.

6.

CAUTION:

Make sure that the battery negative cable does not move

when detaching the negative terminal from the battery.

7.

CONNECT

CAUTION:

Make sure that the battery negative cable to the body

retaining bolt is not loose and fully tightened.

1.

Torque: 13 Nm

Torque: 6 Nm

2.

3.

NOTE:4.

Make sure that both the positive and negative battery

terminals are correctly located.

5.

NOTE:

Where fitted.

NOTE:

Using Jaguar approved diagnostic equipment, reset the

battery monitoring system (BMS).

6.

This step is only necessary when installing a new battery.

Refer to: (501-11 Glass, Door Window Motor Initialization

Frames and Mechanisms, General Procedures).

7.

Enter the audio unit preset radio frequencies.8.

Reset the clock to the correct time.9.

Start the engine and allow to idle until the engine reaches

normal operating temperature.

10.

Switch the engine off.11.