Upload
balluff-inc
View
1.584
Download
7
Embed Size (px)
DESCRIPTION
Download this presentation if you are interested in installing tags in your own tool holders. For information on Balluff tool ID check our website at http://www.balluff.com/Balluff/us/ProductsChannel/Overview/en/Tool+ID.htm
Citation preview
BIS C Series RFIDTool Holder Tag Installation
www.balluff.com
Industrial Identification
Installation Procedure
• Drill Tag Hole• Clean Install Surface• Tag Installation• Curing Note• Installation Protection and Safety
www.balluff.com
Industrial Identification
Drill Tag Hole
• Always fixture tool holder• Bore hole based on tool holder type
and tag dimensions• Always reference recommendations for
tag location
Tool Holder
Example
www.balluff.com
Industrial Identification
Drill Tag Hole
• Drill location and bore dimensions for BIS C-122-04/L tags accordingly– Use DIN 69893 for HSK type A – F holders
• Example:– Data carrier dim.: 10 X 4.5mm
– Bore dim.: 10mm +.09/-0 Dia. x 4.6mm +.2/-0 depth
www.balluff.com
Industrial Identification
Cleaning
• Clean surface of metal chips, dust and grease.
• Acetone or thinner for nitrocellulose lacquer can be used.
• Same solvents can be used to clean excess adhesive before hardening.
www.balluff.com
Industrial Identification
Tag Installation
• Recommended bonding material• Use two component Loctite Hysol 1C
– Balluff Part number: • Loctite Hysol 1C
• Roughen smooth side surfaces of data carrier (tag).
• Roughen sides of drilled hole.• Mix ratio is 2.5:1.0 or 250 parts
hardener to 100 parts adhesive.
www.balluff.com
Industrial Identification
Tag Installation
• Apply Adhesive to both data carrier and hold.
• Place data carrier completely in hole.• Be sure part number of data carrier
can be read.
www.balluff.com
Industrial Identification
Installation Curing
• 72 hours approx. curing time at room temp. (Depends on temp and mixture. Follow epoxy directions.)
• Applying heat can increase final bond strength.• Curing at 60° C for 2 hours improves bond to 12.1 N/mm²
www.balluff.com
Industrial Identification
Epoxy Warnings
• Follow warnings on Loctite datasheet!• Protect against direct contact with skin.• Solvents should not be used for cleaning epoxy skin contact.• Perform work in well ventilated area.• Read Loctite technical datasheet!
www.balluff.com
Industrial Identification
Any Questions?
www.balluff.com
Industrial Identification
Thank you!