A u t o m a t i c Tr a ffi c D e n s i t y M o n i t o r i n g a n d C o n t r o l S y s t e m

Presented by- Amit Bhoosan Atul Rai Mitilesh Manish

INTRODUCTION:

• In today’s context, time is a big issue for all. Being a engineer the motto of

our team model is to reduce the mental irritation to time waste in traffics. And to simplify the system.

•  • In urban scenario 1st,2nd,3rdtier cities have traffic light system for controlling

crowd of vehicles,but this traffic light system is not so efficient that can save time in many conditions.

•  • There are many employees who works in private and government

organizations,generally the office timing is 10:00am to 05:00pm at that time crowd have on its peak ,that makes condition of jam.

•  • So for reducing the condition of jam we are making a project on it.

Automatic traffic density monitoring and control

 • Traffic density monitoring and control system is a electrical and electronics based

project.• This project keeps importance in today’s busy life because of its long life and cost

efficientness. • At any cross road with four ways or more ,there are traffics with different levels on

every road.In general we have three color light on traffic control.

Red- ‘STOP’ Yellow- ‘READY’ Green- ‘GO’• In any traffic light signal every light blink for 60sec (red, green) in general.• There are conditions when a side road have less traffic then other sides.• This model works on the idea of monitoring density of the roads and regulating the

traffic accordingly .• In the system with traffic lights ,it needs to get improve for much fruitful result

because there is possibility that the density on one road is high and for 60secs the controller is allowing an empty road .

• To avoid such unwanted situation proposed in model to use Traffic Density Monitoring And Controlling System .

side1

side2

side4

side3

Time management according to given figure

RED GREENSide1 40 sec 50 sec

Side2 70 sec 20 sec

Side3 20 sec 70 sec

Side4 20 sec 70 sec

side1

side2

side3

side4

COMPONENT USED

IR Receiver module IR Transmitter

ARDUINO UNO R3

LED(RED) LED(GREEN)

WORKING:

 • Output of IR receivers will be provided to the microcontroller and processed

accordingly. • The number of IR receiver is generating the positive signal is denoting the specific

density of vehicle on lane. • At that point the ray is received by the IR receiver, which were transmitted by IR

sensors. When any vehicle standing between the path of IR ray, then can not be avail to receive signal.

• Accordingly the data of all four lanes will be provided with the controller and the lane with highest number of density will be allowed to pass.

• This idea can save time, reduce pollution and money of individual .

atm

el32

8p

+VCC

GRD

THANK YOU