1. Using electric dies to cut threads on steel pipe
CPCP3001A
Fabricate and install fire hydrant and hose reel systems
2. Fire hydrant and hose reel fabrication job
3. Ridgid electric thread cutting dies
4. Foot switch
5. Center pipe in chuck jaws and lock with hand wheel
6. To cut pipe - lower pipe cutter ontomark and turn handle
clockwise slowly
7. The cut pipe- note the burr?
8. Use the deburring tool to remove the internal burr before
cutting the thread
9. Move the self opening die head into position-operate foot pedal-
check oil flow to cutters and turn carriage hand wheel to cut
thread
10. Move die head back to resting position and pipe is ready for
removal and installation
11. Ridgid electric roll grooving machine
12. Roll groove former heads
13. Insert reamed end of pipe onto drive shaft and support pipe
with forward pressure towards drive shaft
14. Foot pedal
15. Apply downward pressure on the feed handle whilst operating the
foot pedal
16. Lower the feed handle slowly this will ensure that the
grooveremains even until the handle is lowered fully
17. Completed roll groove on pipe ready for installation
18. It is recommendedthat you view the Ridgid training videos on
cutting and threading steel pipe before proceeding.
http://www.ridgid.com/video/1224threadISDN.asf
19. If you are unsureabout the use of this equipment or the steps
involved in the cutting-threading and grooving of steel pipeyou
shouldconsult with your trainer beforeproceeding.
20. End of slide show
