TurboTurbo
Catch CanCatch Can
Air intakeAir intake
Boxer EngineBoxer Engine
CrankCrank
LH LH Rocker Rocker CoverCover
RH RH Rocker Rocker CoverCover
Stock Setup – Catch Can DisconnectedStock Setup – Catch Can Disconnected
© FINER9
TurboTurbo
Catch CanCatch Can
Air intakeAir intake
Boxer EngineBoxer Engine
CrankCrank
LH LH Rocker Rocker CoverCover
RH RH Rocker Rocker CoverCover
Stock Setup – Catch Can ConnectedStock Setup – Catch Can Connected
Using OEM T-point.Using OEM T-point.Block the crank Block the crank breather inletbreather inlet
Note: If you are connecting a catch can with only two Note: If you are connecting a catch can with only two connections one inlet and one outlet. Follow the same connections one inlet and one outlet. Follow the same
instructions and leave out the Crank breather line. instructions and leave out the Crank breather line.
© FINER9
How I mounted the catch canHow I mounted the catch can
© FINER9
General Idea of were the lines goGeneral Idea of were the lines go
Crank Case Breather LineCrank Case Breather Line
Catch Can Air return LineCatch Can Air return Line
T-’ed into Rocker covers T-’ed into Rocker covers linked line linked line
© FINER9
LH to RH Rocker Cover lineLH to RH Rocker Cover line
To Catch CanTo Catch Can
Angle Of photoAngle Of photo
Connect the Catch can to the Connect the Catch can to the rocker covers line. Trace the line rocker covers line. Trace the line between the rocker covers and between the rocker covers and find the T-where it branches off find the T-where it branches off to the air intake, located closer to the air intake, located closer to the RH cover it is under the to the RH cover it is under the
intake manifold.intake manifold.
If you have some firm hosing If you have some firm hosing just line it up from the other side just line it up from the other side of the manifold and push it onto of the manifold and push it onto
the T like in the photo.the T like in the photo.
© FINER9
© FINER9
Angle Of photoAngle Of photo
Crank Breather outletCrank Breather outlet
To Catch can
The original crank breather hose is quite short. Disconnect it from The original crank breather hose is quite short. Disconnect it from the air intake and block this entry. I ran my line from the outlet the air intake and block this entry. I ran my line from the outlet from the crank under the rear of the intercooler and back to the from the crank under the rear of the intercooler and back to the
catch can.catch can.
If you do it this way make sure the new hosing does not touch or If you do it this way make sure the new hosing does not touch or rub under the bottom of the intercooler.rub under the bottom of the intercooler.
Air intakeAir intakeTo Catch CanTo Catch Can
This is the Catch can return line. It returns the cleaned air back to the air-intake hopefully This is the Catch can return line. It returns the cleaned air back to the air-intake hopefully without oil. I ran this line along the front of the intake manifold. Because it is neater, however it without oil. I ran this line along the front of the intake manifold. Because it is neater, however it
took a lot of patience to feed the line through. I like it because it looks almost factory.took a lot of patience to feed the line through. I like it because it looks almost factory.
© FINER9