Products Used
Put down the saw...Quick and clean install without cutting any of the vehicle sub-dash or relocating the OnStar/WiFi module.
2014-2018 Silverado/Sierra Radio Replacement
StingerElectronics.com
TECH TIP
Stinger ELEV8 (UN1880)
Best Kits: BKGMK325BMAmerican Intl: GMK325BM
PACRP5-GM51
PACSAT-01
Remove the center trim panel around radio display. Remove 4 x 7mm screws and 2 connectors to remove the factory radio display.
Depending on which factory audio system is installed (4 or 7”), there will be 1, 2 or 3 modules behind the display. FIG A
Unplug and remove the GM Radio Module. Remove CD/DVD Module if equipped. The ELEV8 Radio Module can be installed in the upper space and the bottom space can be used for the RP5 module, sat tuner and any other peripherals. FIG B
Refering to yellow cutline in FIG C,use your favorite power tool to cut the plastic dash mount bracket.
Refering to the yellow cut line in FIG D, cut both side brackets.
Note: For the side brackets, you can score the plastic with a utility knife and then break apart.
GM Radio Module
OnStar Module
FIG C FIG D
2x
R L
CUT OFF APPROX 1.25”
CUT FLUSHALONG TAB
FIG B
FIG A
ELEV8 Radio Module
RP5 MODULE, SAT TUNER... ETCCD/DVD PLAYER
1. Disassembly
2. Prepping the Kit
TECH TIP
1. Attach the Clamp Assembly to the back of the ELEV8 display using four M4 X 12 screws.
2. Attach display to the plastic dash mount-ing bracket. The rubber boot will not be used.
3. Cut and remove center rib from main bracket and file smooth.
4. Attach the modified left and right side brackets. Attach ISO spacers to the inside upper sections on both left and right side brackets. (Refer to kit instructions for more information).
Slide the ELEV8 assembly into the the kit. Ad-just depth and angle to desired position. Use four #10 X 3/8 coarse thread screws, includ-ed in the ELEV8 harware pack, to attach radio mounting bracket to side brackets. Two screws per side. FIG E
Note: There are multiple mounting holes on the mounting bracket and side brackets to allow adjustment and alignment. If needed, you may drill additional holes in the mount-ing bracket and/or the dash kit brackets to align and secure the display in the best position.
FIG E
x x
1 2
3 4
3. Display & Kit Assembly
4. Display Adjustment & Mounting
NoteIn most cases the bottom edge of the display will be resting on the dash kit. Adding a small piece of felt or foam tape in the center will ensure there is no squeaks or rattles.
Do you have ELEV8 install to share? Send us the details and get some Stinger swag - [email protected]