HANDLE JOG MODE
The HAAS ControlSeries
PRESS
THREE TIMES TO GET TOTHIS PAGE
(Continued onnext slide)
Note:
SLIDE LEGEND
ACTIONS
INSTRUCTIONS
KEYS
INFORMATION
To advance through the presentation
click on your left mouse button
or press <ENTER>.
To exit press <ESC>.
To advance through the presentation
click on your left mouse button
or press <ENTER>.
To exit press <ESC>. OTHER INFORMATION
HANDLE JOG MODEThis module is
intended to provide you with a
familiarizationof the Handle Jog Mode on the Haas
Control
Here is where you find the Handle Jog Buttons
Pressing the Handle Jog button on the control will display the Position screen. Used to manually move the machine axes by using the Jog Keys or the Hand Wheel.
Handle Jog Buttons
HANDLE JOG:
.0001 .1:
.001 1.:
.01 10.:
.1 100.:
Handle Jog Button:
Handle Jog Button:
Press<HANDLE JOG>
This will bring up the Position screen that will allow you to move the machine axes by using
the Jog keys or the Hand wheel.
If you select the DIST-TO-GO display, it will
zero all axes when you select the Handle Jog
Mode of operation.
POSITION (EDIT) O91002 F1 KEY TURNS MENU ON/OFF
(OPERATOR) (WORK G54)
X 0.0000 in X 12.1705 in
Y 0.0000 in Y 8.0000 in
Z 0.0000 in Z 0.0000 in
(MACHINE) (DIST TO GO)
X 0.0000 in X 12.1705 in
Y 0.0000 in Y 8.0000 in
Z 0.0000 in Z 0.0000 in
JOGGING AXIS @ FEED 1.
Resolution/Feed Rate Buttons:
These four keys select Hand wheel Resolution and the Jog Feed Rate.
The number on the top indicates Hand wheel
Resolution.(Amount of movement
per click)
The number on the bottom indicates the
Jog Feed Rate in inches per minute when using
the Jog keys.
An axis must be selected for movement
to occur.
POSITION (EDIT) O91002 F1 KEY TURNS MENU ON/OFF
(OPERATOR) (WORK G54)
X 0.0000 in X 12.1705 in
Y 0.0000 in Y 8.0000 in
Z 0.0000 in Z 0.0000 in
(MACHINE) (DIST TO GO)
X 0.0000 in X 12.1705 in
Y 0.0000 in Y 8.0000 in
Z 0.0000 in Z 0.0000 in
JOGGING AXIS @ FEED 1.
Handle Jog:While jogging the machine, the FEED RATE OVERRIDE buttons will adjust, in increments of +/-10%, the feed rate that is programmed into the control.
The Hand Wheel can be used to adjust, in increments of 1%, the feed rate that is programmed into the control.
Handle Jog:With the spindle running, the SPINDLE OVERRIDE buttons will adjust, in increments of +/-10%, the speed that is programmed into the control.
The Hand Wheel can be used to adjust, in increments of 1%, the speed that is programmed into the control.
Handle Jog:
The JOG LOCK key will cause the axes you are jogging to continue jogging. Press <JOG LOCK> then press the axis key you want to jog.
While in motion, you can switch axis by pressing the axis you want to move.
Motion will stop by pressing <JOG LOCK>, <FEED HOLD> or <RESET>.
Prepared by Haas AutomationTraining DepartmentOxnard, CA 93030