Phone : 91-9632839173
AUTOMATIC IRRIGATION SYSTEM
INTRODUCTION
In this fast growing electronic world any work or any operation can be done
by sitting in a remote place. No need to go near work place. In this project
irrigation can done by automatically.
DESCRIPTION
This project “AUTOMATIC IRRIGATION SYSTEM” contains 8-bit
microcontroller P89V51RD2, RELAY, alphanumeric LCD, ALARAM, water
sensor and power supply. Here first it will check for the level in the tank, if level
in the tank is low, it will display the tank is empty fill the tank and ALARAM will
make sound. Once tank is filled it will check for WATER sensor output, if it is
high means no need of water, if it is low means water is needed then motor will be
switched on till WATER sensor has to give high output.Once WATER sensor got
high output motor will be switched off.
8051 architecture based P89V51RD2 microcontroller from NxP is used to
implement this project. Microcontroller acts as the heart of the project, which
controls the whole system. It contains 1k RAM, 64k Flash, 3 Timers, 2 external
interrupts, 1 UART, 32 GPIO’s, ISP programming support etc. KEIL IDE is used
to program the microcontroller and the coding will be done using Embedded C.
E-mail: [email protected]; http://www.wavedigitech.com Phone : 91-9632839173
Phone : 91-9632839173
BLOCK DIAGRAM
COMPONENTS USED
1. Microcontroller P89V51RD2-NxP
2. GSM Module
3. GSM Mobile
4. DC Motor Driver
5. DC Motor
6. Buzzer
7. Alphanumeric LCD
8. Power Supply
E-mail: [email protected]; http://www.wavedigitech.com Phone : 91-9632839173
P89V51RD2
LCD(16X2)
RELAY
ALARAM
AC MOTOR
WATER SENSOR
RESET
POWERSUPPLY 5V,12V DC
Phone : 91-9632839173
SOFTWARES USED
1. Embedded C
2. Keil Compiler
3. Flash Magic
E-mail: [email protected]; http://www.wavedigitech.com Phone : 91-9632839173