Warning!

All information contained herein are the properties of Tim Nash. Do not

duplicate or distribute this side show with my permission!

Start-up Screens

• First Start-up Screen

Start-up Screens

• Second Start-up Screen

Start-up Screens

• Fourth Screen. You can see the LED’s are

flashing.• (I missed the third

screen)

Start-up Select Screen

• After the start-up screens, the controller waits for an input from the operator for 5 seconds. If no input, the controller loads the last settings by default.

OEM Settings load

• The factory settings are:• V-Boost on – 6000 rpm• V-Boost full- 8000 rpm• Shift Light – 9000 rpm• Rev Limit – 10000 rpm

New Settings Screen

• Three button menu selects the new settings for v-boost, rev limit, and shift.

V-Boost On Screen

• Adjust to set when the v-boost starts to open the servo.

V-Boost Wide Open

• Adjust to set RPM where the V-Boost is wide open.

Rev Limit Screen

• Adjust to set the Rev Limit RPM.

Shift Light Screen

• Adjust to set the shift RPM

Saving Screen

• This is displayed when any setting has been modified.

Smoking Screen

• This is displayed after an adjustment to the v-boost settings.

Key on, bike off screen

Idle Reading

Yee-Ha Button

• Fully opens v-boost at 1800 RPM with out going threw all the screens (just in case a v-rod happens by on a Sunday).

Wide Open %

• Controller is indicating V-Boost output. Output is scaled and indicated in 10% increments.