Upload
minh-vien
View
218
Download
0
Embed Size (px)
Citation preview
7/28/2019 TU BU trung the
1/6
HCMC. PC SPECIFICATION
MEDIUM VOLTAGE POWER CAPACITOR 200KVAR
I. SCOPE :This specification should be applicable to outdoor medium voltage powercapacitor intended for power factor correction of medium alternatingvoltage power system.
II. STANDARD OF MANUFACTURE AND TEST :IEC 871 : Shunt power capacitors for AC systems having a rated voltage
above 660 V.
III.DESCRIPTION :
A. SERVICE CONDITIONS :
The capacitor shall be designed and fabricated, suitable for outdoor
service in Ho Chi Minh City, Vietnam under the following conditions:- Altitude : Up to 40m above sea level- Ambient air temperature :
+ Maximum : 55C+ Highest mean over any period of 24 hours : 45C+ Highest mean over any period of 01 year : 35C
- Maximum relative humidity : 95%- Climate : Tropical, salty atmosphere, industrial contamination.- Solar radiation : 1000W/m2
- Maximum wind velocity : 30m/s- Lightning stroke expectancy : 120 thunderstorm days per year.
B. CONSTRUCTION :
- The medium voltage power capacitor shall be single phase unit.- Type of service : outdoor.- Rated voltage (Un) : 8.66 KV.- Rated current (In) : 23A.- Rated frequency : 50 Hz.- Rated capacity : 200 KVAR- Maximum permissible voltage :
+ 12hours in every 24 hours : 110 % Un+ 30 min. in every 24 hours : 115 % Un+ 05 min. in every 24 hours : 120 % Un+ 01 min. in every 24 hours : 130 % Un
- Maximum permissible current :+ Continuous operation : 130 % In+ Maximum current : 150 % In
- Maximum permissible capacity : 135 % of rated capacity.- Tolerance of capacitance : - 5 % to + 10 % of rated value.- Dielectric :
+ Material : All film+ Impregnation : Non-PCB, Faradol 600 or Jarylic
- Total power losses : 0.1 W/kvar./var/www/apps/conversion/tmp/scratch_2/138239072.doc 1/6
7/28/2019 TU BU trung the
2/6
HCMC. PC SPECIFICATION
MEDIUM VOLTAGE POWER CAPACITOR 200KVAR
- Power frequency withstand voltage :+ Dry test for 1 minute : 60KV+ Wet test for 10 seconds : 50KV
- Lightning impulse (1.2/50s) withstand voltage : 125 kV.- Build-in discharge resistor : Reduces terminal voltage to 50VAC or less
from initial peak voltage of 2 times rated voltage within 5 minutesafter disconnection of unit.
- Number of bushing : 02- Creepage distance : 25mm/KV
- Insulation resistance between terminal and container : 1000 M.- Terminals : tin-plate parallel groove type for copper conductor range
from 10-50mm2- Tank : Stainless steel
Safety, not-rupture even fault situation is required
-Life expectancy for 5% failure : 50 years.
- Accessories :+ Studs, connectors and earth bars or conductors shall be provided to
permit the connection of all metal works and electrical equipment toearth.
+ 02 bird caps.
IV. TESTING REQUIREMENT :
1. Testing items :
a. Routine tests :- Capacitance measurement.
- Capacitor loss tangent (tan) measurement.- Voltage test between terminals.- AC voltage test between terminals and container.- Test of terminal discharge device.- Sealing test.
b. Type tests :- Thermal stability test.
-Capacitor loss tangent (tan) measurement at elevated temperature.
- AC voltage test between terminals and container.- Lightning impulse voltage test between terminals and container.- Short circuit discharge test
2. Requirements :
In order to ensure the quality of supplied goods , in case of bid winning ,the Tenderer shall supply routine test and copies of type test report metthe following requirements:
a. Routine test shall be performed for each equipment.
b. Type test report shall meet the followings :/var/www/apps/conversion/tmp/scratch_2/138239072.doc 2/6
7/28/2019 TU BU trung the
3/6
HCMC. PC SPECIFICATION
MEDIUM VOLTAGE POWER CAPACITOR 200KVAR
- Testing sample : The same as the supplied item (manufacturer,original country, manufactures code as specified in tender document).
- Testing items : Including testing items according to IEC 871.- Testing values shall be corresponding values as stated in Section III
of this specification. If in section III, there are no corresponding values,testing values will be selected according to the standard specified insection II of this specification.
V. REQUIREMENT OF TECHNICAL TENDER DOCUMENT :
- Technical description, data sheets, catalogues and other materialsubmitted with the quotation must enable the buyer's engineers tothoroughly evaluate the proposals as to its compliance with the inquiryspecifications.
- Minimum requirements :+ Detailed summary of deviations to inquiry specification.+ Completed inquiry data sheet expressed at clause VI.+ Type test report met the requirements as specified section IV.+ Brochures and catalogues containing outline dimensions, main
electrical dataand installation details.+ Certificate of quality management.
VI. DATA SHEET :
No SPECIFICATION UNIT REQUIREMENT TENDER
1. Item No.2. Manufacturer3. Country4. Manufacturers code5. Standards of factory and
testIEC 871
6. Standards of quality
management7. Member approve ofcertificate ofmanagement
8. In case of bid winning ,the Tenderer shallsupply routine test andcopies of type testreport met therequirements of sectionIV .
Yes
A. SERVICECONDITIONS
9. The capacitor shall be/var/www/apps/conversion/tmp/scratch_2/138239072.doc 3/6
7/28/2019 TU BU trung the
4/6
HCMC. PC SPECIFICATION
MEDIUM VOLTAGE POWER CAPACITOR 200KVAR
designed and fabricated,suitable for outdoorservice in Ho Chi MinhCity, Vietnam under thefollowing conditions:
10. Altitude Up to 40m above sealevel
11. Ambient air temperature:+ Maximum+ Highest mean overany period of 24 hours+ Highest mean overany period of 01 year
CC
C
5545
35
12. Maximum relativehumidity
% 95
13. Climate
14. Solar radiation W/m2 100015. Maximum wind velocity : m/s 3016. Lightning stroke
expectancy :120 thunderstorm
days per year.
B. CONSTRUCTION :
17. The medium voltagepower capacitor shall besingle phase unit.
Yes
18. Type of service Outdoor19. Rated voltage (Un) KV 8.6620. Rated current (In) A 2321. Rated frequency Hz 5022. Rated capacity KVAR 20023. Maximum permissible
voltage ::
+ 12hours in every 24hours: 110 % Un
+ 30 min. in every 24hours: 115 % Un
+ 05 min. in every 24hours: 120 % Un
+ 01 min. in every 24hours: 130 % Un
110% Un
115% Un120% Un130% Un
/var/www/apps/conversion/tmp/scratch_2/138239072.doc 4/6
7/28/2019 TU BU trung the
5/6
HCMC. PC SPECIFICATION
MEDIUM VOLTAGE POWER CAPACITOR 200KVAR
24. Maximum permissiblecurrent :+ Continuous operation+ Maximum current
130 % In150 % In
25. Maximum permissiblecapacity
135 % of ratedcapacity
26. Tolerance of capacitance
- 5 % to + 10 % ofrated value.
27. Dielectric :+ Material+ Impregnation
All filmNon-PCB, Faradol
600 or Jarylic28. Total power losses W/kvar
. 0.1
29. Power frequencywithstand voltage :+ Dry test for 1 minute+ Wet test for 10seconds
KVKV
6050
30. Lightning impulse
(1.2/50s) withstandvoltage
KV 125
31. Build-in dischargeresistor
Reduces terminalvoltage to 50VAC
or less from initialpeak voltage of2times rated
voltage within5 minutes afterdisconnection of
unit32. Number of bushing 0233. Creepage distance mm/K
V25
34. Insulation resistance
between terminal andcontainer
M. 1000
35. Terminals Tin-plate parallelgroove type for
copper conductorrange from 10-
50mm236. Tank Stainless steel37. Safety, not-rupture even
fault situation is requiredYes
38. Life expectancy for 5%failure 50 years
39. Accessories :
/var/www/apps/conversion/tmp/scratch_2/138239072.doc 5/6
7/28/2019 TU BU trung the
6/6
HCMC. PC SPECIFICATION
MEDIUM VOLTAGE POWER CAPACITOR 200KVAR
+ Studs, connectors andearth bars or conductorsshall be provided topermit the connection ofall metal works andelectrical equipment toearth.+ 02 bird caps.
Yes
Yes
/var/www/apps/conversion/tmp/scratch_2/138239072.doc 6/6