===============================================To enable telnet session and swaping the Builds===============================================;telnetd -debug 23 &STEP 1: First see that your downloaded build is in active partition is or not by following command: esm_build_info all For active partition /tmp/passive/bin/esm_build_info all For passive partitionSTEP 2 : if you dont have your downloaded build then swap the build by following command: test_hlEeprom swapActivePartition test_hlEeprom swapActiveSomSoftware=================================M_trm logs===============================ukpt bc rp3m commis hwmgt c for enable the DSP ml2monitor -I set=LMP -E set=LMP -i add=NP_GE0 -e add=NP_GE0filter to be applied on wireshark(udp port 32785 and greater 61) or udp port 13100 or udp port 13001tshark.exe -i 2 -f "udp port 32785 or udp port 13100 or udp port 13001" -b filesize:10000 -w "C:\Documents and Settings\labuser\Desktop\Captain"For ESMAml2monitor -I set=SS1 -E set=SS1 -i add=DTRX1 -e add=DTRX1 for each DTRX if it doesn't contain ESEAml2monitor -I set=SS1 -E set=SS1 -i add=DTRX6 -e add=DTRX6 for sites which contain ESEA====================================================================TSHARK Capturing commands===========================C:\Program Files\Wireshark\tshark.exe" -i 1 -f "capture filter if any" -b filesize:10000 -w "logs path"C:\>"C:\Program Files\Wireshark\tshark.exe" -i 1 -b filesize:10000 -w "C:\Documents and Settings\labuser\Desktop\Abis Logs Congestion\abis_congestion_.pcap"=================================================================================================================