Remove the 4 upper tie-down hooks. Keep the 8 Torx bolts, but do not reuse the tie-down hooks.

I t e m N o . 3 1 8 3 0 0 0 4 - 3 0 - 1 6 0 9 DD

Truck Hero5400 S. State RoadAnn Arbor, MI 48108734 677-0444, Fax: 734 677-8409 Truck Hero Inc. 2016 Printed in U.S.A.

2017 Honda Ridgeline

SUPPLEMENT TO TONNEAU INSTALLATION INSTRUCTIONS

T50 Torx driver7/16” Wrench

Tools Required:

Register your warranty at:

Front, upper tie-down hooks.Both sides.

Rear, upper tie-down hooks.Both Sides.

Align the parts for assembly as shown.

Honda Ridgeline Accessory Rail Right15003102

Honda Ridgeline Accessory Rail Left15003104

Tap Plate, 22000000

Accessory Bracket Mount, 22000100

Screws, 1/4-20 x 3/4LG S.H.C.S25000800

Cab Bracket Mount, 27002010(notice the slotted holes are on the top)

Tail Bracket Mount Left, 27002014

Tail Bracket Mount Right, 27002012

(Notch is at thetailgate end)

Truck-Hero.com

3 1 8 3 0 0 0 4 - 3 0

Slide two of the accessory bracket mounts intoeach rail. Align with the rail interior prole as shown.

Truck Hero Inc. 5400 S. State Road Ann Arbor, MI 48108 734 677-0444, Fax: 734 677-8409 Visit us at truck-hero.com

Slide one accessory bracket mount to the front, leavingthe other at the tailgate end of the rail.

(Notch is at thetailgate end)

With the accessory bracket mounts slid into the rails, assemble the brackets as shown. Loosely tighten the screws.

Accessory Rail LeftAccessory Rail front, copied on left and right

Tap Plate

Tap PlateAccessory Bracket Mount

Accessory Bracket Mount

ScrewsScrews

Cab Bracket Mount(notice the slotted holes are on the top)

Tail Bracket Mount Left

Tail Bracket Mount Right

Accessory Rail Right

Tap Plate

With the brackets mounted to the rails, place the rails on the truck. Position the rail so the front cap pad rmly contacts the bulkhead. Align the brackets so that they line up with the factory tie-down hook bolt holes, then thread in the factory bolts and tighten.

Tighten the front hardware while pushing down on the rail to make good seal contact with the truck bed at the same time also pushing the rail forward to keep good contact between the cap pad and bulkhead.Continue to push down on the rail while tighteningthe rear bracket hardware.

Cap padto bulkhead

Tighten both Torx bolts,then tighten bothAllen head bolts.Tighten both Torx bolts,

then tighten both Allenhead bolts.

A

B

Push downPush down

1

12

2