Steps to set up Code Composer Studio (CCSv4): The shipping demo for the PIL implementation using PMSM is intended for Texas Instrument’s (TI’s) F28335 eZdsp board which operates at a clock rate of 150 MHz.

One of the steps in running the PIL demo involves, installing CCSv4 and verify that it can connect with the F28335 eZdsp board. Below are snapshots of the steps to be taken to create a target connectivity configuration to verify that CCS can connect and talk to the board.

If you have any questions related to these steps or this demo please send us an email at mytarget@mathworks.com

Creating a target connectivity configuration:

Step 1:

Step 2:

Step 3

Step 4

Step 5

Step 6

Step 7

If the debugger runs withour errors at this point, you have verified that the board is connected to and is communicating with Code Composer studio!

You will now be able to run the MathWorks PMSM PIL demo to dowmload the algorithm to the hardware and test it using PIL simulation.

To the Target configuration that has been saved: start at step 5.