Upload
trinhmien
View
220
Download
4
Embed Size (px)
Citation preview
Seed Tube GuardFor John Deere, Kinze (pre 3000 series) and White (6000/8000) Planters
Two Year Money Back Satisfaction GuaranteePrices Subject to Change without Notice
R K PRODUCTS INC. 3802 Jean Street, East Moline IL 61244 800-580-6818309-792-1927 Fax 309-792-1924 www.rkproducts.com
OEM seed tube guards typically wear down to ½” by the end of an average season. The majority of the wear occurs early in the season. As the furrow becomes narrower planting depth decreases and becomes more erratic. The opener disks should be adjusted deeper to compensate. Increased compaction and glazing of the furrow side walls may result.
Plugging between opener disks and gauge wheels can be a serious problem. Worn gauge wheel arm pivots are the main cause by allowing the tires to pull away from the opener disks. Badly worn seed tube guards allow the disks to flex farther inward and contribute to the problem. The RKP guards should reduce this problem.
The nearly constant width and the flat bottom of the furrow produced by the RKP guard will allow the seed to more consistently reach a uniform depth. The flat bottom will not be compacted or glazed which should result in more uniform emergence.
Revised08/23/17
Shank Mounting Deere XP Mounting
Regular mounting for Deere, Kinze & White Planters
3/16” Heat Treated Steel Bracket
Heat treated steel bushings minimize wear.
Guides keep seed tube centered on guard.
Wear plates provide several times more wear area than OEM
Fertilizer Tube Attachment uses
same nuts and bolts as guide to attach to guard.
Furrow width is maintained and seed tube is protected many times
longer than with OEM guards.
A 5/16” rivet and capscrew clamp bushings between sheet metal halves of shank assembly. An excellent installation will be realized even with badly worn holes.
Special bushings with 3/8” hardware are available for p lan te r s tha t have been repaired with the new JD guard that uses 3/8” roll pins.If 5/16” holes are badly worn you can repair them by drilling them to 3/8” (no larger).
Prices: $60 each Seed Tube Guard with
Tungsten Carbide Alloy Wear Plates
$45 each Seed Tube Guard withHigh Chrome Content
(Welded Hard Coating)
$12 each Fertilizer Tube Attachment
NOTE: orders under $200 have a $15 shipping fee ALL DOMESTIC ORDERS OVER $200 FREE SHIPPING in US