THIS BLOCK OF COLOR BLEEDS OFF THE PAGE 1/8” ON ALL SIDES.SAME WOULD GO FOR IMAGES OR PHOTOS THAT ARE PLACED AT THE EDGE

OF THE PAGE.

San MarinoEnamel Glass & Coordinating Ceramic Wall Tile

D E S I G N S

RoseannSan Marino by

Shown Here:Matte Chevron Mosaic

in Fawn

Gloss Herringbone Mosaic

Smoke

Slate

Sapphire

Sky

Sage

Seafoam

Pearl

Smeralda

Frost

Colonial Blue

Fawn

Cloud

Dove

Blue Grass

Matte Bubble Mosaic

Matte Field Tile w/ Polished Dot Basketweave Mosaic

Frost and Black Frost and Sapphire

Pearl and Fawn Frost and Sky Frost and Cloud

Mix #3Pearl, Frost, and Fawn

Mix #1Smeralda, Frost, and

Seafoam

Mix #2Dove, Frost, and Cloud

Shown Here:Gloss Herringbone Mosaic

in Cloud

Matte Chevron Mosaic

Smoke

Slate

Sapphire

Sky

Sage

Seafoam

Pearl

Smeralda

Frost

Colonial Blue

Fawn

Cloud

Dove

Blue Grass

Matte Cube Mosaic

Cube #6Sage, Frost, and Colonial Blue

Cube #5Black, Frost, and Charcoal

Cube #4Slate, Frost, and Blue Grass

Cube #3Dove, Smoke, and Cloud

Cube #2Smeralda, Frost, and Seafoam

Cube #1Pearl, Frost, and Fawn

Shown Here:Gloss Herringbone Mosaic

in Cloud

Matte Hexagon Mosaic

Smoke

Slate

Sapphire

Sky

Sage

Seafoam

Pearl

Smeralda

Frost

Colonial Blue

Fawn

Cloud

Dove

Blue Grass

2”x8” Coordinated Gloss Wall Tile

Sapphire

Slate

Smoke

Cloud

Fawn

Pearl

Frost

Snow

Colonial Blue

Smeralda

Blue Grass

Sky

Sage

Seafoam

Dove

Trim Pieces

2”x8.5” Molding in Gloss.75”x8.5” Pencil in Gloss .625”x8.5” Quartino in Gloss

* Trim Pieces Available in All Colors

Shown Here in Shower:Gloss Herringbone Mosaic in Cloud

Matte Bubble Mosaic in Mix 2Shown Here Outside Shower:

Basketweave Mosaic in Frost and Black

Installation Instructions for Enamel Glass

Installation Instructions:

1. Setting - Any setting product that is recommended for use with glass mosaics can be used for the enamel glass.

2. Sealing - The matte finish glass/enamel tile requires the use of a sealer prior to grouting so that the grout color does not get into the pores (similar to stone). This will reduce the risk of grout pigments entering the pores and changing the color of the product. The gloss finish does not require sealing prior to grouting.

3. Grouting - Allow adhesive to cure for 24 hours prior to grouting.

Matte finish - Take caution with the type of grout used because if the sealer gets into the joint, the grout can become discolored. We have tested and recommend Tec Power Grout. This proved to be the best grout for color consistency and clean-ability.

Gloss finish - any non-sanded grout may be used.

Uses:

Gloss - 1. Any wall application, interior and exterior.2. Light duty floors.3. Can be used in submerged wet areas, mud showers, and steam showers.

Matte - 1. Any wall application, interior and exterior.2. Light Commercial Floors.3. Can be used in submerged wet areas, mud showers, and steam showers.

Light colors - 1. Light colors can be used for floor applications, however they tend to show dirt quickly. They can be easily cleaned. This is not recommended in commercial areas.

Maintenance: 1. Use a neutral detergent for cleaning.2. Rinse with clean water and dry with a clean cloth.3. Do not use abrasive brushes. **2”x8” Wall tile for wall installation only.

**All products should be inspected prior to installation. Claims for defective product will not be accepted after installation.

Features Test Method Requirements Results

Facial Defects ANSI A 137.2 7.1 The samples shall be within tolerance for facial defects

Complied

Structural Defects ANSI A 137.2 7.1 The samples shall be within tolerance for structural defects

Complied

Thickness ASTM C499 ≤0.76mm .43mm

Nominal Size ASTM C499 ±10.00% -2.54%~-0.04%

Caliber Range ASTM C499 ±5.00% -1.10%~+1.14%

Static Coefficient of Friction ASTM C1028 As Reported Dry: 0.83Wet: 0.61

Dynamic Coefficient of Friction

Refer to ASTM C1028 As Reported Dry: 0.60Wet: 0.55

Water Absorption ASTM C373 ≤0.5% 0.03%~0.05%

Acetic Acid, 3% and 10% (v/v)

ASTM C650 As Reported Not affected

Ammonium Chloride, 100g/L ASTM C650 As Reported Not affected

Citric Acid Solution, 30g/L and 100g/L

ASTM C650 As Reported Not affected

Lactic Acid, 5% (v/v) ASTM C650 As Reported Not affected

Phosphoric Acid 10% (v/v) ASTM C650 As Reported Not affected

Sulfamic Acid, 30g/L and 100g/L

ASTM C650 As Reported Not affected

Sodium Hypochlorite Solution, 20mg/L

ASTM C650 As Reported Not affected

Hydrochloric Acid Solution, 3% and 18% (v/v)

ASTM C650 As Reported Not affected

Potassium Hydroxide, 30g/L and 100g/L

ASTM C650 As Reported Not affected

Chemical Resistance Class ANSI A 137.2 5.2.3.5 As Reported Class A

Waterproof ink black ASTM C1378 As Reported Not affected

Washable ink ASTM C1378 As Reported Not affected

Potassium permanganate solution, 1%

ASTM C1378 As Reported Not affected

Methylene blue solution, 1% ASTM C1378 As Reported Not affected

Stain Resistance Class ANSI A 137.2 52.3.6 As Reported Class A

Linear Thermal Expansion ASTM C372 As Reported N/A

Moisture Expansion ASTM C370 As Reported N/A

Thermal Shock Resistance ANSI A 137.2 7.9 Pass Fully Resistant

Frost Resistance ASTM C1026 Pass Fully Resistant

Glass Tile

Product info:l Glass Tilel Gloss and Matte Finishl Frost Resistance = Yl Contact your sales representative for more information www.galleriastone.com

THIS BLOCK OF COLOR BLEEDS OFF THE PAGE 1/8” ON ALL SIDES.SAME WOULD GO FOR IMAGES OR PHOTOS THAT ARE PLACED AT THE EDGE

OF THE PAGE.

Shown Here:Gloss Herringbone Mosaic

in Sapphire