Upload
doxuyen
View
237
Download
0
Embed Size (px)
Citation preview
REMINDERS: Problem Set 2: Due Monday (Feb 3) Midterm 1: Next Wednesday, Feb 5
- Lecture material covering chapters 1-5 - Multiple Choice, Short Answers, Definitions - Practice midterm will be on course website - Closed-book, no notes, no calculator. - No scantron or blue book necessary
UPCOMING REVIEW SESSION:
- Tuesday, Feb 4, 6:30-8:00pm in HSS 1330
Clarifications: 1) I noted on Wednesday, that as a whole, clouds cool the surface. But earlier I said that at night, the presence of a cloud will warm the surface. ???? Clouds have 2 effects on surface temp: a) reflect solar radiation => cools surface b) emit infrared radiation => warms surface AT NIGHT, process (a) is gone, so only left with (b)
Clarifications: 2)
tropopause
Since in tropopause warm air beneath cold air => wouldn't that mean tropopause is always unstable? No, because as we will see, when air rises it cools. The atmosphere only unstable if rising air is warmer than surrounding air.
Which of these situations is more likely to be unstable?
(A) (B)
cold air
cold air warm air
warm air
So, on this question I should have used the wording.....
Stability
Is the Atmosphere Stable or Unstable? Question we ask to see if air will rise. If air rises, clouds may form.
Stable: Air parcel pushed up a little, but returns to original level Unstable: Air parcel pushed up a little,
and continues to rise.
Also must consider that as air moves up (or down) in the atmosphere, it's temperature will change. ==> changes in pressure cause expansion or compression
Clicker Question
If no condensation takes place, rising air will cool at a rate of approximately 10°C/km. What would happen IF condensation was taking place within the rising air parcel? (A) the air parcel would cool at a faster rate (B) the air parcel would cool at a slower rate (or may even warm) (C) would have no impact on cooling rate
Set Clicker Frequency to AD
Clicker Question
An air parcel at the surface has a temperature of 30°C and a dew point temperature of 20°C. Assume dry adiabatic lapse rate = 10°C/km. T = 30°C, TDEW = 20°C, ΓDRY = 10°C/km Assuming TDEW does not change, at what height will condensation start forming as the air rises? (A) 0.5 km (B) 1.0 km (C) 1.5 km (D) 2.0 km
Set Clicker Frequency to AD
Clicker Question
Continuation of last question:���Condensation begins at 1 km (this is cloud base) where T=20°C. The air continues to rise to 2 km (this is cloud top). What is the air temperature at 2 km? ΓD = 10°C/km, ΓM = 6°C/km (A) 10°C (B) 14°C (C) 20°C (D) 30°C
Set Clicker Frequency to AD
- Rising unsaturated air cools at Dry Adiabatic Lapse Rate ΓD=10°C/km - Rising saturated air cools at Moist Adiabatic Lapse Rate ΓM=6°C/km - Sinking air warms at Dry Adiabatic Lapse Rate ΓD=10°C/km
0 m
1000 m
Environment
30°C
26°C
Stability Test Case 1 ΓE=4°C/km
ΓE=4°C/km
0 m
1000 m
Environment Rising Air (dry)
30°C
26°C
30°C
20°C Parcel colder than surroundings ⇒ cold air more dense than warm air ⇒ parcel sinks back down ⇒ Stable (returns to starting point)
Stability Test Case 1 ΓE=4°C/km
ΓE=4°C/km
- Rising unsaturated air cools at Dry Adiabatic Lapse Rate ΓD=10°C/km - Rising saturated air cools at Moist Adiabatic Lapse Rate ΓM=6°C/km - Sinking air warms at Dry Adiabatic Lapse Rate ΓD=10°C/km
0 m
1000 m
Environment
30°C
16°C
Stability Test Case 2 (ΓE=14°C/km)
ΓE=14°C/km
- Rising unsaturated air cools at Dry Adiabatic Lapse Rate ΓD=10°C/km - Rising saturated air cools at Moist Adiabatic Lapse Rate ΓM=6°C/km - Sinking air warms at Dry Adiabatic Lapse Rate ΓD=10°C/km
0 m
1000 m
Environment Rising Air (dry)
30°C
16°C
30°C
20°C Parcel warmer than surroundings ⇒ warm air less dense than cold air ⇒ parcel continues to rise ⇒ Unstable
Stability Test Case 2 (ΓE=14°C/km)
ΓE=14°C/km
- Rising unsaturated air cools at Dry Adiabatic Lapse Rate ΓD=10°C/km - Rising saturated air cools at Moist Adiabatic Lapse Rate ΓM=6°C/km - Sinking air warms at Dry Adiabatic Lapse Rate ΓD=10°C/km
0 m
1000 m
Environment Rising Air (moist, RH=100%)
30°C
16°C
30°C
24°C Parcel warmer than surroundings ⇒ warm air less dense than cold air ⇒ parcel continues to rise ⇒ Unstable
If parcel was saturated (RH=100%) ⇒ parcel temp = 24°C at 1000 m ⇒ parcel even warmer ⇒ more unstable ⇒ more moisture = more unstable
Stability Test Case 2A (ΓE=14°C/km)
ΓE=14°C/km
- Rising unsaturated air cools at Dry Adiabatic Lapse Rate ΓD=10°C/km - Rising saturated air cools at Moist Adiabatic Lapse Rate ΓM=6°C/km - Sinking air warms at Dry Adiabatic Lapse Rate ΓD=10°C/km
Height
Temperature
ΓDRY (10°C/km)
ΓM (6°C/km)
Height
Temperature
ΓDRY (10°C/km)
ΓM (6°C/km) ΓENV
(4°C/km)
Height
Temperature
ΓDRY (10°C/km)
ΓM (6°C/km) ΓENV
(4°C/km)
h
TD TE TM
TD < TE TM < TE
Height
Temperature
ΓDRY (10°C/km)
ΓM (6°C/km) ΓENV
(4°C/km)
h
TD TE TM
TD < TE TM < TE => STABLE
Height
Temperature
ΓDRY (10°C/km) Stable
ΓM (6°C/km)
Stable Atmosphere: Often occurs during clear night as - surface cools a lot - air above cools a little (air is selective absorber)
temperature profile at sunset
Stable Atmosphere: Often occurs during clear night as - surface cools a lot - air above cools a little (air is selective absorber)
temperature profile at sunset
much cooling at surface
little cooling of air above
Stable Atmosphere: Often occurs during clear night as - surface cools a lot - air above cools a little (air is selective absorber)
temperature profile at sunset
temperature profile at sunrise
much cooling at surface
little cooling of air above
Stable Atmosphere: Clouds that develop in stable atmosphere tend to be STRATUS clouds
Height
Temperature
ΓDRY (10°C/km) Stable
ΓM (6°C/km)
ΓENV (14°C/km)
Height
Temperature
ΓDRY (10°C/km) Stable
ΓM (6°C/km)
ΓENV (14°C/km)
h
TD TE TM TD > TE TM > TE
Height
Temperature
ΓDRY (10°C/km) Stable
ΓM (6°C/km)
ΓENV (14°C/km)
h
TD TE TM TD > TE TM > TE => UNSTABLE
Height
Temperature
ΓDRY (10°C/km) Stable
ΓM (6°C/km)
Unstable
Unstable Atmosphere: Often occurs during strong daytime heating - surface warms fast - air above warms slow (air is selective absorber)
Unstable Atmosphere:
- Air forced upwards will continue to rise
- As air rises, Temperature decreases and RH increases
if RH=100% => condensation and cloud formation => latent heat released => possibility of storm formation
Clicker Question
Which type of clouds are more likely to form in unstable conditions? (A) stratus clouds (layered) (B) cumulus clouds (vertically developed) (C) fog (cloud in contact with surface)
Set Frequency to "AD"
Unstable Atmosphere: Clouds that develop in unstable atmosphere tend to be CUMULUS clouds
Height
Temperature
ΓDRY (10°C/km) Stable
ΓM (6°C/km)
Unstable
ΓENV (8°C/km)
Height
Temperature
ΓDRY (10°C/km) Stable
ΓM (6°C/km)
Unstable
ΓENV (8°C/km)
h
TD TE TM TD < TE TM > TE
Height
Temperature
ΓDRY (10°C/km) Stable
ΓM (6°C/km)
Unstable
ΓENV (8°C/km)
h
TD TE TM TD < TE TM > TE => STABLE or UNSTABLE???
Height
Temperature
ΓDRY (10°C/km) Stable
ΓM (6°C/km)
Unstable
Conditionally Unstable
Conditionally Unstable Atmosphere Whether unstable or not depends on moisture amount more moisture in air => more likely to be unstable
1. WHAT CAUSES ATMOSPHERE TO BECOME MORE/LESS UNSTABLE? 2. WHAT CAUSES AN AIR PARCEL TO INITIALLY RISE?
1. WHAT CAUSES ATMOSPHERE TO BECOME MORE/LESS UNSTABLE?
1. WHAT CAUSES ATMOSPHERE TO BECOME MORE/LESS UNSTABLE? ONE WAY IS THROUGH MIXING => Rising Air Cools
Sinking Air Warms
Temperature
Height initial profile of environment air
compresses and warms
expands and cools
Height
Temperature
ΓDRY (10°C/km) Stable
ΓM (6°C/km)
Unstable
Conditionally Unstable
1. WHAT CAUSES ATMOSPHERE TO BECOME MORE/LESS UNSTABLE? ONE WAY IS THROUGH MIXING => Rising Air Cools
Sinking Air Warms
Temperature
Height initial profile of environment air
compresses and warms
expands and cools
1. WHAT CAUSES ATMOSPHERE TO BECOME MORE/LESS UNSTABLE? ONE WAY IS THROUGH MIXING => Rising Air Cools
Sinking Air Warms
Temperature
Height initial profile of environment air
compresses and warms
expands and cools
final profile of environment air
Another way the atmosphere can become more unstable: The large-scale lifting an entire layer of air - here a large-scale layer of air is much larger than a parcel
- layer may be 100's of kilometers across
- the lifting of a layer typically happens with a low pressure system (more later in course)
1000 m
Temperature
Height
- Original layer (in blue) is very stable
1000 m
1500 m dry adiabatic lapse rate (10C/km)
Temperature
Height
- Original layer (in blue) is very stable - As layer rises, it expands - As air rises => cools at dry adiabatic lapse rate (10°C/km) (assume no condensation)
1000 m
1500 m dry adiabatic lapse rate (10C/km)
Temperature
Height
- Original layer (in blue) is very stable - As layer rises, it expands - As air rises => cools at dry adiabatic lapse rate (10°C/km) (assume no condensation) - Top of layer rises 500 meters more than bottom of layer
=> Top of layer cools more than bottom of layer
1000 m
1500 m dry adiabatic lapse rate (10C/km)
Temperature
Height
- Original layer (in blue) is very stable - As layer rises, it expands - As air rises => cools at dry adiabatic lapse rate (10°C/km) (assume no condensation) - Top of layer rises 500 meters more than bottom of layer
=> Top of layer cools more than bottom of layer - Result => environment lapse rate within layer more likely unstable
1000 m
1500 m dry adiabatic lapse rate (10C/km)
Temperature
Height
- Original layer (in blue) is very stable - As layer rises, it expands - As air rises => cools at dry adiabatic lapse rate (10°C/km) (assume no condensation) - Top of layer rises 500 meters more than bottom of layer
=> Top of layer cools more than bottom of layer - Result => environment lapse rate within layer more likely unstable This occurs when low pressure over area. Opposite happens with high pressure system.
Low Pressure => Rising Air => Increasing INSTABILITY High Pressure => Sinking Air => Increasing STABILITY
1000 m
1500 m
dry adiabatic lapse rate (10C/km)
Temperature
Height
- Bottom of layer moist (RH=100%), top of layer dry (RH<<100%) - Bottom of layer cools at moist adiabatic lapse rate (6°C/km) - Top of layer cools at dry adiabatic lapse rate (10°C/km)
=> Now even more unstable than before!! CONVECTIVE INSTABILITY
moist adiabatic lapse rate (6C/km) RH=100%
RH << 100%
SPECIAL CASE: CONVECTIVE INSTABILITY