PRO CNC Vertical Workholding

PRO CNC Vertical Workholding v2020Q4.1

PRO CNC Vertical Workholding

Version 2020Q4.1 © 2020 Avid CNC

All Rights Reserved




All Rights Reserved

Gussets

Remove the indicated gussets from the side opposite of the electronics bar.



All Rights Reserved

Clamps

120.00 mm

Install the provided second electronics bar at 120mm (4-23/32") from the bottom of the table. It may be helpful toclamp pieces of wood cut to 120mm, as shown, for spacing and installing the second electronics bar.

Make sure that your original electronics bar is also spaced 120mm from the bottom of the table. It will need to be alignedwith the new electronics bar.

Assembly Note



All Rights Reserved

Gussets

Reinstall the gussets as shown.



All Rights Reserved

Lower Crossmember

Install the lower crossmember so it is aligned with the 2nd crossmember.



All Rights Reserved

Install your preferred vertical spoilboard.



All Rights Reserved

Install a spoilboard to �t.



All Rights Reserved

XX

Alternatively, after the second electronics bar is installed, you can recess the front member a desired amount.



All Rights Reserved

Align the lower crossmember with the now recessed front crossmember.



All Rights Reserved

Install your preferred vertical spoilboard.

Documents

PRO CNC Vertical Workholding