FlexiPacket Series -
FlexiPacket Hub 800(FPH800) Introduction
MWT Shanghai
* 2007 Nokia Siemens Networks. All rights reserved.
Tail / ChainAggregation/CoreService Core ApplicationsAny BTS 2G,
3G, iHSPA, LTE, WiMAXHubFlexiPacket Series Products in
Tail/Chain/Hub Site FlexiPacket RadioFlexiPacket FirstMile
200FlexiPacket Hub 800FlexiPacket Hub 800HCisco/TellabshiT7xxx
* 2007 Nokia Siemens Networks. All rights reserved.
MicrowaveCopperFiberTDMMLPPPATM IMAFEGESTM-1/4GE1U Height4
copper GE (2 P+E)2 SFP option for GE or STM-116xE1/T1 with
75/100/120ohm1 OOB (out of band)/1 DCN1 Alarm1 USB1
1PPS&ToD2xDC Input (-48V)Pluggable FAN tray4xGE optical4xGE
electronics16xE1/T1Power Injector (2
P+E)2xSTM-1/STM-42xFlexiBus2xFPMRCost-effective Modularity Solution
for Complicated Access Domain FirstMile 200MicrowaveCopperFiber
Packet
Diversity of Services/Interfaces supported by Modularity
ArchitectureTwo Option Card SlotsFlexiPacket Hub 800 Main Board
SDH
* 2007 Nokia Siemens Networks. All rights reserved.
4xGE(e)4x10/100/1000BASE
2xFBCompliant to ex-siemens BTS
Any Option Cards on Any Slots, No Limitation!Diversity of Option
Cards adapt for Complicated Access Domain
4xGE(e)4x10/100/1000BASE
IFMax. Quantityper FPH800E148GE SFP10GE
RJ4512STM-16STM-48FB4P+E4FPMR6
* 2007 Nokia Siemens Networks. All rights reserved.
Multi-service Supported by FPH800 & Relative Panels
CESoP/SAToP based on RFC5086/4553 Flexible configuration based on
64K level Flexible packet encapsulation from 1xE1/T1 to 32xE1/T1
Flexible configuration for PWE packet header Adaptive clock
recovery (ACR) supported Data clock recovery (DCR) supported Max
16xE1 per ML-PPP Group 64Kbps based Support ML-PPP protection
Support UDP/IP Head compression Support static IP routing Max 2
16xE1 MLPPP cards supported per chassis Nice to haveFeature on
R2.5FPH800 with 16xRJ48C PanelCC4(1.0/2.3) Panel: 1/2U
Height16xRJ48C Panel: 1/2U HeightBNC Panel: 1U HeightTDM E1/T1 PWE
Supported(CESOP/SAToP)Multilink PPP(ML-PPP)ATM/IMA PWE
* 2007 Nokia Siemens Networks. All rights reserved.
Right Product on MWT Hub Site by Supporting more FlexiPacket
Radio Max 4 P+E ports supported by one FPH800 Up to 2 P+E ports
supported by main board Up to 1 power injector card supported Max
12 Eth ports can be connected to FlexiPacket Radio P+E ports can be
connected to FlexiPacket Radio directly Other ports can be
connected with FlexiPacket Radio through external power injector.
MWR Link protection via CCM 1+1 Hot Standby (HSBY) MWR ring
protection supported2 P+E supported by Mainboard1 Power Injector
cardsupportedEthernet 1Ethernet 2P+E 1P+E 2P+E 3P+E 4Ethernet
1Ethernet 2P+E 1P+E 2External Power
InjectorFM200FM200FM200FPH800MWRRing1+1 HSBYFeatures about
FlexiPacket RadioFPH800 with External Power InjectorFlexiPacket
Radio Interfaces on FPH800FPH800 with Four FlexiPacket Radio
Packet
FPRFPRFPRFPRLAGGE
* 2007 Nokia Siemens Networks. All rights reserved.
Capable for existing SDH aggregation networks Support 2xSTM-1
interfaces on Main Board Combo port with GE SFP Max. support two
STM-1/4 cards Support MSP 1+1 Support EoS (Ethernet over SDH)
Following is supported protocol for EoS: GFP (Generic Framing
Protocol) VCAT (Virtual Concatenation) LCAS (Link Capacity
Adjustment Scheme) Up to 63xE1 can be mapped on each STM-1/4
interface on 2xSTM-1/4 card. Support VC4/VC12 cross-connection
Support up to 8 VCG2xSFP can be Configured to STM-1Two 2xSTM-1/4
card can besupported
SDH
E1Features of STM-1/4 InterfaceInterfaces on Main Board and
2xSTM-1/4 CardFPH800 connected with existing SDH
networksEthEthE1FPRSTM-1/4MSP 1+1
* 2007 Nokia Siemens Networks. All rights reserved.
Compliant to Diversity of Legacy Interfaces Compliant to
ex-Nokia FB interface Max. two 2xFB card is supported No power
feeding on 2xFB card Up to 16xE1 encapsulated per each FB except
the bandwidth for EthernetUp to two 2xFB cardssupportedFB Compliant
to Hybrid FPMR ODU. Max. two 2xFPMR card is supported Standardized
GE RJ45 interface External power injector or Power injector card
can provide power to ODU Native E1 and Native Ethernet are included
on FPMR interface Up to 75xE1 encapsulated per FPMR
interface.2xFPMR cardPower Injector CardFPH800H/FPH220HFPH800FPMR
1+12xFlexiBus (FB) Card2xFlexiPacket MultiRadio (FPMR) CardFPH800
with ex-Nokia Base StationFPH800 connected with FPH800H
* 2007 Nokia Siemens Networks. All rights reserved.
CET E-Line/E-LAN Traffic Supported by FPH800 P2P EVC for E-Line
Each service includes two ports Max 480 services Traffic from one
port forward to another directlyPoint to Point(P2P)Multipoint to
Multipoint(MP2MP)E-Line Network Scenario MP2MP EVC for E-LAN Each
service includes multiple ports Max 480 servicesEach service has
separate MAC address table, and MAC address learning Forward packet
based on MAC addressE-LAN Network Scenario
* 2007 Nokia Siemens Networks. All rights reserved.
Multiple QOS Mechanisms Ingress rate limit per port Unknown
unicast/multicast/broadcast storm control per port sRED dropping
mechanism Queue schedule algorithms as below: SP WRR WDRR Egress
shaping Per port shaping Per queue shapingMulti QoS
MechanismsFlexiPacket Hub800 QoS Model
* 2007 Nokia Siemens Networks. All rights reserved.
Support below SLA (Service Level Agreement) types UNI port
Service Certain classification rule in service SLA parameters CIR
CBS PIR PBSBandwidth GuaranteeFlexiPacket Hub800 SLA Flow
ProcessBandwidth Guarantee
Classification
Mark
Packet
Shaping/drop
Mark
* 2007 Nokia Siemens Networks. All rights reserved.
Ethernet OAM Mechanism 2G/3GEthernet service OAM: IEEE 802.1ag /
ITU-T1731802.3ahEthernet Service OAM Connectivity check: Hardware
based; Max 256 3.3ms/10ms flows supported Loopback / Linktrace
AIS/RDI APS: automatic protection switch Loss Measurement Delay
MeasurementThroughput MeasurementEthernet Link OAM Discovery Remote
failure indication Remote Loopback Threshold crossing
alarmsConnectivity Fault ManagementPerformance ManagementEthernet
Link in FirstMile
* 2007 Nokia Siemens Networks. All rights reserved.
Dual IDU Protection: Equipment Protection Dual IDU protection
supported for connected interfaces with the following three
solutions: Y-Cable: SFP/RJ45 GE can be protected Protection Panel:
SFP/RJ45 GE, E1 can be protected Power Injector: RJ45 GE or 1+0 ODU
can be protectedDual IDU protection supported for connected
interfaces with the right three solutionsY-CableProtection
PanelPower InjectorCable solution for SFP/RJ45 GEPanel Solution for
RJ45/SFP GE, E1Box Solution for 1+0 ODU, RJ45 GEMain Features of
Dual IDU ProtectionDual IDU Outlook
* 2007 Nokia Siemens Networks. All rights reserved.
Dual IDU Protection: Protection Panel for local interfacesIDU#2
8xGE RJ45 ConnectorsIDU#1 8xGE RJ45 ConnectorsUser
8xRJ45132456781326548712634587IDU#22xSFPIDU#1 2xSFP 121212User
8xRJ45IDU#1 16xE1 IDU#216xE1User 16xE1Height: 1ULPGE1/SFP GE/RJ45
GEBTS/Node BProtection Panel: 8xGE RJ45+2xSFP RJ45+16xE1Dual IDU
with Protection Panel
* 2007 Nokia Siemens Networks. All rights reserved.
Dual IDU Protection: Power Injector Panel for ODU
connectionHeight: 1/2UUser 4xGE(ODU or local ports)Alarm PortFor
Dual IDULPGRJ45 GEBTS/Node B1+0 ODUPower Injector Panel: 4xGE(P+E
or no power)Dual IDU with Power Injector
* 2007 Nokia Siemens Networks. All rights reserved.
Interface Protection on Single & Dual IDU1+1 Hot-Standby
Protection On Single IDULAG Protection on Single IDU1+1 Hot-Standby
Protection On Different IDULAG Protection on Different IDU
* 2007 Nokia Siemens Networks. All rights reserved.
Network Protection:
