Embed Size (px)
Citation preview
Installation of
Joining of two Aqua-TraXX lines
IT-FCC636
Connection to submain lines
• Starter fitting with rubber for Polyethylene & PVC
IT-FGA638
PVC/PE 40 to 110 mm
Connection to submain lines
• Starter fitting with rubber and minivalve for Polyethylene & PVC
IT-FVT3966
PVC/PE 40 to 110 mm
How to install 1. Drill a Ø 15 mm hole on
the pipe (using drill cup IT-FHP660)
2. Place the Rubber inside
the hole
3. Press the barbed side of the
Starter IT-FGA638 or
IT-FVT3966 into the rubber
and screw the holding ring
versus the pipe
Connection to submain lines
• Starter fitting with 3/8” grommet for Polyethylene & PVC
PVC/PE 40 to 110 mm
IT-FGP668 IT-FGA645
Connection to submain lines
• Starter fitting with 3/8” grommet and minivalve for Polyethylene & PVC
PVC/PE 40 to 110 mm
IT-FGP668 IT-FVT3957
How to install 1. Drill a Ø 18 mm hole on
the pipe (using drill cup IT-FHP661)
2. Place the “Expander”
gasket IT-FGP668 inside
the hole
3. Using your thumb, press the
“Expander” gasket’s handle
firmly and screw on the Starter
IT-FGA645 or IT-FVT3957
Polyethylene & PVC
Polyethylene & PVC
• Starter fitting for Lay Flat hose
Connection to submain lines
IT-FGP655 IT-FSP675 IT-FGA645 or
IT-FVT3957
1. Using the Lay Flat hole
puncher, punch a hole
on the Lay Flat
How to install
2. Screw the Socket
partially on the button
and insert the flange
3. Tighten the Starter & Socket
How to install
Layflat
Layflat
Layflat
How to close the line
1. First fold
2. Second fold
3. Insert over the fold a cut-
off piece of Aqua-TraXX
