Upload
others
View
1
Download
0
Embed Size (px)
Citation preview
MarineTrafficCOMAR SLR-200N AIS RECEIVERFIRMWARE FLASHING GUIDE
When a new firmware update is available or your receiver becomes unresponsive, you should follow the steps below to execute a firmware flash:
Marinetraffic © 2014
• Download the latest version of DeviceInstaller application:http://ltxfaq.custhelp.com/app/answers/detail/a_id/644
• Install the tool (allow for elevated rights if asked).
• Allow the setup program to install optional components (like .NET Framework) ifneeded.
• Once the setup has finished, run the application. You may see this warning:
• Next, you will see the following prompt:
Tick the Do not prompt me about this checkbox and click OK.
Tick the Do not prompt me about this checkbox and click Yes or No according to your preference.
MarineTraffic
Marinetraffic © 2014
• You will now enter the application's main window:
• On the upper left side you will see the detected IP address of your receiver:
MarineTraffic
Marinetraffic © 2014
• Click on it and the device details will be displayed on the right side of theapplication window:
• Now look at the device summary and determine the hardware revision and theexisting firmware version as shown below:
• Go to this page: http://www.lantronix.com/support/downloads/?p=XPORTClick on the appropriate hardware revision link and download the latest.rom firmware and .cob web interface files for your receiver*.
*X03 and X04 hardware revisions share the same firmware files.
MarineTraffic
Marinetraffic © 2014
WARNINGIF YOU UPLOAD THE WRONG FILES IN
YOUR RECEIVER THE UNIT WILL BECOME UNUSABLE AND / OR DAMAGED!!!
• Save the files on your Desktop.On the application's main window click on the Upgrade option.
• You will see the following window :
MarineTraffic
• Leave the selection as is and click Next:
• Click on the Browse button and point the program to the .rom firmware file youhave downloaded earlier. When finished, click on the Next button:
Marinetraffic © 2014
MarineTraffic
Marinetraffic © 2014
• Select Install files contained in COB partitions and click Next:
• Select Partition #1 and click Set Partition.
• A browse window will appear. Point the program to the .cob file you havedownloaded earlier.Ignore the image size warning and click Yes.
MarineTraffic
• You’ll be presented with the above window. Click Next.
• Click Next.
Marinetraffic © 2014
MarineTraffic
Marinetraffic © 2014
• The firmware update process will initiate. Provided that the procedure finishessuccessfully you should see the following:
• Click on the Close button to close the upgrade window. Return to theapplication's main window to verify that the receiver is discoverable and the newfirmware version has been successfully uploaded.
MarineTraffic
The receiver is now ready for normal operation
MarineTrafficTech Support Team