Manual RK1

8/3/2019 Manual RK1

1/24

IR-PRO

Professio

nalInfraredC

odeCaptureS

ystem

RK1

In-WallUniversal

Controller

RK1Operation & Installation Guidev1.0

8/3/2019 Manual RK1

2/24

FEDERAL COMMUNICATIONS COMMISS

This equipment has been tested and founlimits for a Class B digital device, pursuantRules. These limits are designed to provideagainst harmful interference in a residential

This equipment generates, uses, and can ra

energy and, if not installed and used ininstructions, may cause harmful intcommunications. However, there is no guarwill not occur in a particular installation.

If this equipment does cause harmful inttelevision reception, which can be determequipment off and on, the user is encourageinterference by one or more of the following

Reorient or relocate the receiving antenn

Increase the separation between the receiver.

Connect the equipment into an outlet from that to which the receiver is connec

Consult the dealer or an experienced rahelp.

This device complies with Part 15 of the FCsubject to the following two conditions: (1

8/3/2019 Manual RK1

3/24

RK1 Universal System Controller

SAFETY SUGGESTIONS

Read Instructions. Read all safety and opebefore operating the unit.

Heat. Keep the unit away from heat sourcesheat registers, stoves, etc., including amplifiers

Power Sources. Connect the unit only to an Rsupply.

Power Cord Protection. Route power supply are not likely to be walked on or pinched by

against them, paying particular attention to treceptacles and at the point at which they exit f

Nonuse Periods. Unplug the power supply frothe unit is to be left unused for a long period.

Water and Moisture. Do not use the uniexample, near a sink, in a wet basement, nearnear an open window, etc.

Object and Liquid Entry. Do not allow objectsbe spilled into the enclosure through openings.

Cleaning. The unit should be cleaned only as reoperating guide.

Servicing. Do not attempt any service beyonh d f ll h

8/3/2019 Manual RK1

4/24

LIMITED WARRANTY

Remote Technologies Incorporated warranperiod of one (1) year from the date of pTechnologies Incorporated or an authorizedIncorporated distributor.

This warranty may be enforced by the o

subsequent owners during the warranty poriginal dated sales receipt or other proof opresented when warranty service is required

Except as specified below, this warranty

material and workmanship in this product. covered by the warranty:

Damage resulting from:

1. Accident, misuse, abuse, or neglect.2. Failure to follow instructions contain3. Repair or attempted repair by anyo

Technologies Incorporated.4. Causes other than product defects, i

competence or experience of user.5. Shipment of this product (claims mu6. Being altered or which the serial num

modified or removed.

Remote Technologies Incorporated is not lid b i d f i f il f i

8/3/2019 Manual RK1

5/24


If your RK1 needs service, please contact Re

Incorporated by telephone, fax or e-mail for ret

Please do not return products to Rauthorization.

DISCLAIMER

All rights are reserved. No part of this dphotocopied, reproduced, or translated withounotice of Remote Technologies Incorporated.

The information contained in this document iwithout notice. Remote Technologies Incorpoliable for errors or omissions contained herein odamages in connection with the furnishing, perthis guide.

Microsoft and Windows are registered trademCorporation. Other brands and their productsregistered trademarks of their respective holder

RK1, Its Under Control, TheaterTouch, and

trademarks of Remote Technologies Incorporat

8/3/2019 Manual RK1

6/24

Contents

Federal Communications Commission No

Safety Suggestions -----------------------------

Limited Warranty ------------------------------

Disclaimer-----------------------------------------Contents---------------------------------------------

Chapter 1. Welcome------------------------------

Compatibility Note-----------------------------

Unpacking and Inspection -------------------

Product Contents-------------------------------

Software Requirements -----------------------

Chapter 2. Introduction -------------------------

Features--------------------------------------------

Important Notes --------------------------------

Cleaning ------------------------------------------

Getting Started ----------------------------------

Keypad Reference ------------------------------

Chapter 3. Operation-----------------------------

8/3/2019 Manual RK1

7/24


Chapter 6. Service and Support-------------------

Updates and New Products----------------------

Contacting Remote Technologies Incorporate

RTI Technical Support ----------------------------

Specifications------------------------------------------

8/3/2019 Manual RK1

8/24

Chapter 1. Welcome

Thank you for purchasing the RK1 in-walThe RK1 is a customizable keypad desiginstallations in walls or cabinets. It provcontrol system for controlling audio/video other electronic systems in the home. Siz

electrical box, the RK1 incorporates fully-pwhich can be custom labeled with text and scustom labels, the backlight for each buttondisplay almost any desired color.

The RK1 can directly control almost any aulighting system, etc. up to 1000 feet away usport. Programming is easy and conveWindows based TheaterTouch Designer

Because RTIs remote control products a

professional installers/programmers, andconsumers, it is our philosophy to not incocapability directly into our products. Insteadproviding our dealers with the hardware aallow them to create re-usable program

templates in the most efficient and reliable wThe RK1 can be used as a stand-alone deexpandable central control system. When uRTI accessory devices, the RK1 is capable of

8/3/2019 Manual RK1

9/24


UNPACKING AND INSPECTION

After unpacking your new RK1 universal systall of the packing materials in case you ever hav

Thoroughly inspect the RK1 and packing madamage. Report any damage to the carrier im

any equipment malfunctions to RemIncorporated or an authorized Remote Technodistributor.

PRODUCT CONTENTSContents within the box include the following i

One (1) RK1 universal system controller

One (1) Set of button labels

One (1) Operation & Installation guide

SOFTWARE REQUIREMENTS

The recommended minimum system requirem

the TheaterTouch Designersoftware are as follow Windows 98SE, Windows ME, Window

XP or later version.

A f USB t

8/3/2019 Manual RK1

10/24

Chapter 2. Introduction

FEATURES

The RK1 provides superior quality and reliaspecific features:

Use any standard Decora type face

Fits in single gang outlet box.

Three different cover plate colors ava

Two, four or eight assignable/programodels available.

User-definable backlight color.

Open architecture allows control of v

Easy to use Windows based softwa

and customization.*

Adjustable backlight brightness.

Light sensor for automatic backlight

IR output port drives up to 1000 feet

Completely customizable, programmupgradeable.

8/3/2019 Manual RK1

11/24


IMPORTANT NOTES

Please read these important notes about the RK

The RK1 should be placed in an area w

normal room temperature (between 60F

Avoid installing the RK1 in a location wcontact with direct sunlight.

Do not install the RK1 directly adjacent togenerated by the RK1 may affect tempera

Do not use sharp objects on the buttonoperate with a touch of your finger.

Do not let the RK1 get wet. It should no

wet hands or placed in an area where it co

Do not subject the RK1 to smoke, dust,display may be damaged from excessive s

Only use the power supply that is speUsing the wrong type of power suppdamage.

Do not disassemble the unit Service of

8/3/2019 Manual RK1

12/24

CLEANING

Occasional cleaning may be required, depen

To clean your RK1, lightly dampen a lint-fcleaner or mild detergent, and wipe the bezel, and faceplate.

GETTING STARTED

The RK1 is turned-on by simply applyiprovides two power supply solutions which

Single Unit Power Supply

16VDC, 1.6Amp

Provides power for up to six RK

Part Number: 40-210285-22

CB-4 Connecting Block

Includes 16VDC, 4.3Amp powe

Provides power for up to sixtee Provides a convenient connecti

Part Number: 10-210052-11

8/3/2019 Manual RK1

13/24


KEYPAD REFERENCE

FunctionButtons

Ambient LightSensor

Front View

Cover PlateThreaded Holes

8/3/2019 Manual RK1

14/24

Chapter 3. Operation

THE INTERFACE

The RK1 is a flexible, programmable interfconfiguration, the RK1 buttons can each single function or scene. If more functiobuttons can execute complex macros, jump change backlight colors to provide status fcustomization allows almost any typefunctionality to be created.

BUTTON LABELS

The RK1 includes a set of labels for attachibutton. The label sheets include a wide varithat are appropriate for most common sce

for attaching these labels is as follows:

8/3/2019 Manual RK1

15/24


1. Remove t

2. Place therubber po

3. Replace t

Repeat the steps above for each button, and thecover.

8/3/2019 Manual RK1

16/24

Control Port Pin-Out

Pin 1

Pin 2

Pin 3

Pin 4

Pin 5

Pin 6Pin 7

Pin 8

INFRARED

INFRARED

+16VDC

+16VDC

RK1 Basic Wiring Connect

Stand-Alone OpControl-System Operation

Cat-5 Cable

(Future Use)

(Future Use)

GROUND

GROUND

RS-485 +

RS-485 -

Chapter 4. Installation & Pro

The RK1 is designed for flush-mount inscabinets. It requires an available mountin(50mm) from the front surface of the wall. mounted in a standard single-gang electrica

8/3/2019 Manual RK1

17/24


CONTROL PORT

RK1 IN-WALL UNIVERSAL CONTROLLER

WWW.RTICORP.COM

RK1/01

MASTER/SLAVE PORT

R

SLAVE

Cat-5 Cable

MASTER/SLAVE OPERATION

Two RK1 units can be connected together ucable between the Master/Slave ports on eactwo keypads to sync with each other so thelarger keypad. Any combination of two, four, o

units can be connected together.When configured in this way, only the masconnected via the Control port (for power, IR, will derive power and communications from th

8/3/2019 Manual RK1

18/24

Chapter 5. Troubleshooting

If you are having problems with your Rtroubleshooting tips before contacting techn

If you continue to have problems, see information on contacting RTI technical sup

UNIT DOES NOT POWER ON

Make sure the external power supply is proRK1, and it is functioning properly.

Make sure the RJ-45 plug is attached proper

Make sure power is applied to the correct cothe unit (the Control Port, NOT the Master/

USB COMMUNICATION PROBLEMS

Verify that your PC is running Windows 98

Verify that the RK1 is present in the Humsection of the Device Manager within th

Panel.

Make sure you are using the programmsupplied by RTI and that both ends are conn

8/3/2019 Manual RK1

19/24


If you are still having problems, try adju

Minimum Repeats value in the Theaprogramming software.

If the IR code is executed inside a macro that ccodes, try inserting a small time delay before ththere already is a delay, try increasing it.

8/3/2019 Manual RK1

20/24

Chapter 6. Service and Supp

UPDATES AND NEW PRODUCTS

For news about the latest updates, new proaccessories, please visit our web site at:

www.rticorp.com

CONTACTING REMOTE TECHNOLOGIES

For general info, you can contact RTI at:

Remote Technologies Incorporated

Tel. (952) 253-3100

Fax (952) 253-3131

[email protected]

www.rticorp.com

RTI TECHNICAL SUPPORT

At RTI, customer service and satisfaction isyou are encountering any problems or haveRTI product, please contact RTI Technical Su

RTI provides technical support by telephone

8/3/2019 Manual RK1

21/24


If you are having a problem with hardwar

equipment in your system, a description of thetroubleshooting you have already tried.

If you are having a problem with software,version you have installed, the operating sysdescription of the problem, and any troublealready tried.

If you are calling about a software or programproblem, please be at you computer when yThis will considerably speed up the troublesho

For Technical Support or assistance with contact RTI at:

(952) 253-3137

[email protected]/support

For questions regarding Service or Repair of

contact RTI at:(952) 253-3136

[email protected]

8/3/2019 Manual RK1

22/24

Specifications

Power 9 - 1

Power Management Adjbrigtim

Buttons FixeUse

Backlight RG

Use

Infrared Output Port 200Dri(300

Operating Temperature +32

(0 Operating Humidity 5%

con

Total System Memory 64K(no

Device Capability Totis limem

8/3/2019 Manual RK1

23/24


Front Cover High-i

ABS p

Front Plate Purcha(Decor

Mounting Mount

single Dimensions (H x W x D) 4.1 in (

(46mm

Total Depth in Wall 1.7 in (

Weight 4 oz (1

Warranty One Y

All specifications are subject to change w

8/3/2019 Manual RK1

24/24

IR-P

RO

ProfessionalInfraredCodeCapture

System

R e m o t e T e c h n o l o g i e s I n c o r p o r a t e dR e m o t e T e c h n o l o g i e s I n c o r p o r a t e dR e m o t e T e c h n o l o g i e s I n c o r p o r a t e dR e m o t e T e c h n o l o g i e s I n c o r p o r a t e d7651 Anagram Drive

Eden Prairie, MN 55344

Tel: 952-253-3100

Fax: 952-253-3131

www.rticorp.com

2007 Remote Technologies Inc. All rights reserved. Printed in Taiwan.

Its Under Control

Documents

Manual RK1