LTM

Stubidka Slatina, 221 101201 4

Product name:

Product type:

Manufacturer:

Sponsor:

LABORATORIJ ZA TOPLINSKA MJERENJA d.o.o.(LABORATORY FOR TH ERMAL MEASU REMENTS tfd.)

Stubi6ka Slatina 26, 49243 Oroslavje, CroatiaTel. ++365-19;4 9 -27 40-21, Fax ++385-(0)4 9 -27 -40-04;

e-mail : l tm@ltm.hr; web: www. l tm.hr

FIRE RESISTANCE CLASSIFICATION REPORTFOR CONSTRUCTION PRODUCTS ACCORDING TO

HRN EN 13501-2:2010

No. R-3869/14-1

FIRE RESISTANT SINGLE-LEAF SWING DOOR

M S 1 4

CHOSTELIDIS BROS O.E., "METAL SYSTEM', Terma Papagou56431 Evosmos, Thessaloniki, GREECE

CHOSTELIDIS BROS O.E., "METAL SYSTEM', Terma Papagou str.56431 Evosmos, Thessaloniki, GREECE

/rof1trv6//rV' oio.

a or+4^'7-\

-\"\t' ;) '7

{ v - r - 1 . ) ' t/i -/,'F,:-X rn

E,qg"#

The laboratory has been accredited by the: CROATIAN ACCREDITATION AGENCY - H$A

The laboratory has been notified by the: EUROPEAN COMMISSION (NB)

The laboratory has been approved by the: MINISTRY OF CONSTRUCTION AND PHYSICAL PLANNINGCROATIAN REGISTER OF SHIPPINGBUREAU VERITAS

Test results refer only to test specimens. The test report can be copied only as a whole.Objections to the contents of this report shall be considered only if received within 15 days after issuing this report

Number of paqes: 5oB 28

INTRODUCTION

This classification report defines the classification of the product specimen FIRE RESISTANT SINGLE-LEAFSWING DOOR, type MS 14 in line with procedures specified in the standard HRN EN 13501-2:2010.

1. BASIC DATA OF THE SPECIMEN

1.1. Intended use: FIRE RESISTANT SINGLE-LEAF SWING DOOR, type MS 14 is usedfor closing openings in massive walls on boundaries between firecompartments.It is intended for preventing the spread of fire between two firecompartments.

FIRE RESISTANT SINGLE-LEAF SWING DOOR, type MS 14 is describedentirely in the test report this classification report is based on.

1.2. Description:

2. TEST REPORT

3. TEST RESULTS

No. R-3869/14-1

Test results refer onlv to test soecimens. The classification report can be copied onlv as a whole.

LTMPage:215

LTM d.o.o. (Lfd.)Stubidka Slatina 26

49243 OroslavjeCROATIA

CHOSTELIDIS BROS O.E...METAL SYSTEM".Terma Papagou str.

56431 Evosmos, Thessaloniki,GREECE

t-3869/14-1(25r09t2014) HRN EN 1634-1:2008

EN 1634-1:2008

t-3869/14-1(25t09t2014)(specimen A)

E - lntegrity:- excessive cracks- ignition of the cotton pad

> 36 min> 36 min> 36 min

l1 - Insulation:- average temperature increase > 140 K- maximum temperature increase > 180 K (25 mm

> 36 min22 min

12 - Insulation:- average temperature increase > 140 K- maximum temperature increase > 180 K (100 mm)- maximum temperature increase on the door frame > 360 K

> 36 min> 36 min> 36 min

W - Thermal radiation > 15

#Dg"@--3'Rro"*"-,"-9

oB-28

No. R-3869/14-1

(-) not measured, because temperature increase over 300"C is not expected

4. CLASSIFICATION AND FIELD OF DIRECT APPLICATION

4.1. Classification references: This classification has been carried out in accordance with the standardHRN EN 13501-2:2010. clause 7.5.5.

4.2. Classification: FIRE RESISTANT SINGLE-LEAF SWING DOOR, type MS 14 (described inthe aforesaid test report) can be classified into one of the following classes.No other classifications are permitted.

LTMPage: 3/5

Fire resistance classification: Elr 15 / E1230

I

Test results refer onlv to test specimens. The classification report can be cooied onlv as a whole.

EN 1634-1:2008

t-3869/14-1(25t09t2014)(specimen B)

- excessive cracks- ignition of the cotton pad

> 36 min> 36 min> 36 min

lr - Insulation:- average temperature increase > 140 K- maximum temoerature increase > 180 K (25 mm

> 36 min1 8 m i n

lz - Insulation:- average temperature increase > 140 K- maximum temperature increase > 180 K (100 mm)- maximum temperature increase on the door frame > 360 K

> 36 min> 36 min> 36 min

W - Thermal radiation > 15 kWm2

E 15 20 30Elr 15El' 15 20 30EW 20 30

oB-28

No. R-3869/14-1

4.3. Field of directapplication:

LTMPage:415

Based on positive test results, the following variations are permitted ascompared to the tested specimen of class E1230, without the need ofadditional assessments, calculations or approvals.Direct application of test results is determined in the standardHRN EN 1634-1:2008, clause 13, and it refers to the tested productspecimens described in the test report no. l-3869/14-1 of 2510912014.

The door structure (leaf and door frame) shall be the same as in the testedspecimen described in the test report no. l-3869/14-1.This classification report is valid only for the fire resistant single-leaf swingdoor.Dimensions of the metal frame may be increased, to adapt it to the thicknessof the load-bearing structure. The type of metal shall not change, and itsthickness may be increased by mostly 25%.The density of the insulation material shall not be reduced, but may beincreased. The door mav be manufactured with or without a doorstep.

Painting the door with paints that do not influence the door fire resistance ispermitted.

The number of anchor bolts for the fixation to the wall may be increased.The gap between the rough opening and the door frame may be reduced,but not increased.Placement is permitted in massive walls of minimum 30 minutes fireresistance.

Hardware replacement is permitted with the hardware of equal dimensions,with proven equivalent properties, i.e. tested on equal or similar doors.The number of hinges, locks and other lock elements may be increased, butnot reduced.The lock shall be fixed at the same height or higher in proportion to theincreased door height.The distance between the upper hinge and the upper edge of the door shallbe equal or less than the distance on the tested door.The distance between the bottom hinge and the bottom edge of the doorshall be equal or less than the distance on the tested door.The distance between the middle hinge and the door shall be equal or lessthan the distance on the tested door.When three hinges are used to prevent deformations, the distance betweenthe bottom of the door and the middle hinge shall be equal or larger than onthe test specimen.

The door size may be reduced by mostly 50% in width and 75o/o in height,whereat the number of hinges, locks and other movement mechanisms maynot change.The door size may be increased by mostly 15o/o in width and 15o/o in height,whereat the total surface increase mav not exceed 20%.

4.3.1 . Door structure:

4.3.2. Decorat ive l in inqs:

4.3.3. Door frame

4.3.4. Hardware:

4.3.5. Door size:

#1}\i*pv.g,l

Test results refer only to test soecimens. The classification report can be cooied onlv as a whole. oB-28

No. R-3869/14-1

4.4. Limitations:

LTMPage:5/5

This classification report does not represent approval or product certification.The classification report validity period depends on the validity period of thetest report, and lasts mostly 5 years.The authorized institution can extend the validity of this report after theexpiry of this period.

This report is valid until22l1012019.

DIRECTOR:

e---\(viii;F;a;G;, E).s.1

CLASSIFICATION PREPARED BY:

I

Test results refer onlv to test specimens. The classification reoort can be copied onlv as a whole.

f-RS,.b.am'3) Stamp@ /5

Qo:t;l"*9

oB-28