Steps in commissioning Kathrein CCU1. Connect the Ethernet cable
between PC and CCU.2. Set your PC Ipv4 settings to IP Address:
192.168.249.2 and 255.255.255.0 for Subnet Mask.3. Open your
browser (Chrome, Firefox, and Internet Explorer).4. Open the
following address in the browsers Address bar: 192.168.249.2495. A
pop-up will appear asking for username and password, the default
username and password is kathrein (without the quotation).6. Click
CCU Status and check for the firmware version, it should be 2.02,
if not proceed by clicking Software Updates and browse for the
firmware update file then upload, wait until finished updating.7.
In the CCU page shown below, and change the CCU Ethernet IP with
the required IP (see Note 1), 255.255.255.252 for the CCU Subnet
Mask, and the required CCU Gateway Address (see Note 2) then click
Save Setup. The CCU will be rebooted after confirming to reboot CCU
twice. 8. Once the CCU has rebooted change your PC Ipv4 settings:a.
IP Address = CCU Gatewayb. Subnet Mask = 255.255.255.2529. On your
browser enter the CCU Address you have entered and it will ask
again for username and password, same username and password as
before.10. Once on the CCU page, click again the CCU Setup and
enter all information, example shown below. Click Save Setup once
all data were entered, you may also set the date and time of the
system.
11. Continue by clicking Devices Setup and click Import Bus Scan
Results once all RET were connected via AISG. Once all RET device
are shown click Save Devices Setup.
12. Now click Devices Status it will show the status of each RET
device.
13. Click Details for each RET device and enter required data
and set the Down Tilt Value.a. For RFS antenna: Upload the antenna
config file for the specific antenna type installed. In the Antenna
Data File click Choose File and browse for the correct antenna
config file then click Upload.b. For Kathrein: Find the correct
antenna type on the dropdown list.
14. Do the same for the other RET devices.
Notes:Note 1: For the CCU Ethernet IP Address it is in the
ManagementSubnet3G (static) column but plus 2 on the last digit,
for example:
Z23023: The Management Subnet is 10.78.120.44 then the CCU
Ethernet Address is 10.78.120.46
Note 2: For the CCU Gateway Address it is the CCU Ethernet
Address but minus 1 for the last digit, following the example CCU
Ethernet Address above the CCU Gateway Address is 10.78.120.45
Created by: Alexander F. EnriquezDate Created: March 05,
2014Revision: RET_1.00
