DATA SHEET KAST-O-LITE 30 LI G DESCRIPTION: Kast-O-Lite 30 LI G is a high alumina, lightweight insulating gun mix. It has a hydraulic set and is suitable for use up to 1650°C. It can be used as both a hot face and back-up lining. APPLICATIONS: Typical applications for Kast-O-Lite 30 LI G are aluminum furnace stacks, aluminum holding furnace doors, reheat furnace discharge doors, carbon black furnace back-up linings, petrochem heaters, sulphur recovery unit back-up linings and air heaters. CHEMICAL ANALYSIS - Calcined Basis Silica – SiO 2 .................................................................................................. 35.5% Alumina – Al 2 O 3 .................................................................................................. 57.5% Iron Oxide – Fe 2 O 3 .................................................................................................. 0.7% Titania – TiO 2 .................................................................................................. 1.5% Lime - CaO .................................................................................................. 4.0% Magnesia - MgO .................................................................................................. 0.2% Alkalies – Na 2 O + K 2 O .................................................................................................. 1.0% NOTE The test data shown are based on average results of control tests and are subject to normal variation on individual tests. These results cannot be taken as maximum or minimum requirements for specification purposes. Ref: 166/4/9/08
DESCRIPTION: Kast-O-Lite 30 LI G is a high alumina, lightweight
insulating gun mix. It has a hydraulic set and is
suitable for use up to 1650C. It can be used as both a hot face
and back-up lining. APPLICATIONS: Typical applications for
Kast-O-Lite 30 LI G are aluminum furnace stacks, aluminum
holding
furnace doors, reheat furnace discharge doors, carbon black
furnace back-up linings, petrochem heaters, sulphur recovery unit
back-up linings and air heaters.
NOTE The test data shown are based on average results of control
tests and are subject to normal variation on
individual tests. These results cannot be taken as maximum or
minimum requirements for specification purposes.
Ref: 166/4/9/08
KAST-O-LITE 30 LI G
PHYSICAL PROPERTIES
Gunned Data
MAXIMUM RECOMMENDED TEMPERATURE 1650C QUANTITY REQUIRED Net 1570
Kgs/m3 BULK DENSITY Kgs/m3 Cured and Then Dried at 105C 1550 - 1730
Heated at 820C 1490 - 1670 MAXIMUM TIME FROM ADDING WATER TO
PLACING MATERIAL
10 Minutes
PERMANENT LINEAR CHANGE ASTM C113 AND C865 Expansion or
Shrinkage Cured and Then Dried at 105C Heated at 820C and Then
Cooled Heated at 1100C and Then Cooled Heated at 1370C and Then
Cooled Heated at 1600C and Then Cooled
