Upload
others
View
7
Download
0
Embed Size (px)
Citation preview
JPT Skylake Update BIOS+ME SOP 1. Please check the EFI folder is setting the same as below picture.
(Disk\Removable disk\EFI\BOOT\)
2. Please check the ME update place is Disabled(as below picture).
3. Booting to EFI shell mode.
(How to enter the prompt command that please key-in FS0: (have non HDD
device) or FS1: (have the HDD device).
4. Go to the JPT B-150 BIOS folder and key in the update BIOS command
**(FPT.EFI –F XXXXX.ROM) as below picture.
**(FPT.EFI –F XXXXX.ROM -BIOS)
(The “-BIOS” command isn’t included the ME firmware update)
5. After finished, remove AC power directly
6. Insert AC power again and then power on the unit
7. Press DEL to go to BIOS setup menu
8. Press F9 for load BIOS setup default
9. Press F10 for save & exit BIOS menu
10. Done.